VP Racing Battery 11.1v 1450mAh 25C LiPo Crane Stock Battery - Tamiya

VP Racing Battery
Code: LP311
£18.99
  • 11.1v
  • 1450mAh
  • Crane Battery

A high output VP Racing 11.1v 1450mAh LiPo battery, designed to deliver some serious rate of fire and trigger response with the right setup.

Full description

Charge this battery the right way...

Description

The battery is also know as a Butterfly battery, as the cells are connected via wire allowing them to be placed down the side of barrels or in an M4 Crane Stock. The battery supplies 11.1v and 1450mAh of current, making it great for high rate of fire and Airsoft weapons with aftermarket components to handle the higher rate of fire provided by this battery. These types of batteries can also be used in remote control Cars, Boats, Planes and other Toys, as well as in DIY Electronics projects.

Product Details

  • 11.1v LiPo
  • 1450mAh
  • 25c
  • Designed for handguards and stocks
  • Will run up to a whole days Airsoft game with a slow charge
  • Small Tamiya connector
  • Approx. 12.5cm x 2.2cm x 2cm
  • 6mm thick cells
  • 8.5cm cable

Package Includes

  • 11.1v 1450mAh 25C LiPo Crane Stock Battery - Tamiya
  • Instruction Manual

Special Instructions

Please note that we only recommend that this battery be used in Highly upgraded guns, and as such we cannot provide a warranty on any gun which has had an 11.1v battery used on it.

Please do not let the battery fully discharge before recharging, this will damage the battery, please use a LiPo Alarm to check the Charge of the Battery before use, and stop if the Rate of Fire Drops. To charge the battery you MUST use a Li-Po Battery Charger, as overcharging can cause damage to the unit.

Never leave Li-Po charging unattended - Always monitor the charging process of your Li-Po so that you can react immediately to any potential problems. If your batteries start to balloon or swell up discontinue charging / discharging. Before and after the use of your Li-Po batteries, inspect them to ensure there is no physical damage or swelling as those are signs of an imminent failure. 

Only use approved Li-Po chargers. Do not pierce or disassemble the battery. The charging current should not be ore than 1.0c as charging at a higher current may damage the cell or even lead to overheating or leakage. Stop charging immediately when temperature is over 45°C, and stop using the battery once the temperature is over 60°C.

We recommend that all LiPo batteries be charged in a fire resistant location, and inside a Fire Proof bag, such as the VP Racing Battery Giant Power LI-PO GUARD Charging Bag.

Specification

General

Product Length
Approx. 12.5cm
Product Height
Approx. 1.8cm
Product Width
Approx. 2.2cm
Patrol Base - Warning Icon
Warnings
Li-Po - Never Leave Charging Unattended
Li-Po - Only Use Approved Chargers
Li-Po - Charge in a Fire Safe Area

Battery Specification

Battery Type
Li-Po
Battery Configuration
Crane
Battery Connector
Patrol Base | Icon | Mini Tamiya
Mini Tamiya
Battery Voltage
11.1V
Battery Amperage
1450mAh
Battery Discharge Rate
25
Battery Cell Count
3
Battery Cell Voltage
3.7V
Battery Cell Height
0.6cm
Battery Wire Length
8.5cm

Size guide

Airsoft Battery should only be charged with the chargers as they are specifically designed to work with the specific voltages required by the battery.

Different battery types have different chemical configurations, and require certain chargers to charge them. Charging a battery with the wrong charger can cause damage to the battery and charger, and can cause fires and further damage. Please ensure that before charging you double check that you are using the correct charger.

If your charger supports multiple battery types always ensure that it is on the correct settings before starting the charge.

We always recommend charging LiPos and other batteries in a charging bag.

If you are unsure of what battery or charger you have please get in touch with us via the Contact Us Page.