All Airsoft Batteries

If you need a battery for your handguard or full stock battery compartment this should do the trick! The 7.4v 1600mAh 25C LiPo Battery from Giant Power is nice and compact, measuring 9.5x1.2x3cm approximately, making it great for handguard battery compartments in SMG-5 and AR36 AEGs and also an easy fit in M16 and AK full stocks.

The battery is pre-wired with a mini-Tamiya battery connector and is in block configuration, meaning both cells are bound together. The wire length between the battery itself and the connector is approximately 10cm and the continuous discharge rate is 25C, making this battery ideal both for Airsoft and any electronics hobby which requires a compact power source.

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a Deans connector (aka a T-Plug) and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A compact 7.4v two cell stick battery that is ideal for squeezing into small spaces like stock tubes, especially the battery spaces on Honey Badgers and compact weapons with an extending skeleton stock.

An ideal battery for those who have very limited space or for those who have a front wired PEQ box style setup or RC cars. With a 1000mAh 30C discharge expect a good rate of fire but 2 or 3 are recommended for a full day of constant shooting.

If you're after a slim stick battery for a top-wired AK, the Giant Power 11.1V 1500mAh 25C LiPo Slim Stick Battery will do the trick! Ideal for slim and long battery compartments in top-wired AK replicas, this LiPo battery measures approximately 16.5cm x 1.5cm x 1.6cm, with a 5cm wire length, and is pre-wired to a Deans/T-plug battery connector. This battery can also be used in M16A1 or A2 fixed stocks and AR buffer tubes, though you will be unable to collapse the stock when installed in a standard buffer tube. 

Please note: 11.1V LiPo batteries can cause pre-engagement in AEGs at UK power levels. This can result in internal damage. Please ensure you only use 11.1V batteries in AEGs designed for them (see "Specifications" on our AEG product pages for battery recommendations). 

An 11.1v 1200mAh 20c LiPo Battery with a Deans Connector in a Stick configuration, making it ideal for Solid Stocks and some rear wired Buffer Tubes. It has the following dimensions with a 9cm cable: 2cm x 1.63cm x 13cm.

If you are looking for a decently sized crane stock battery which should last all day, the VAPEX 7.4v 2200mAh 20C LiPo Crane Battery should do the trick! This battery is a 7.4V 2S LiPo in crane/nunchuck configuration, meaning the cells are separated into two individual units which makes the battery far easier to fit into unconventionally shaped battery compartments. The pre-wired connector is the common mini-Tamiya connector and the continuous discharge rate is 20C.

Each of the individual cell units measures 11x2.2x1.2cm approximately with a wire length of 9cm between each cell and the connector, meaning this should fit nicely in most crane stocks and many handguards and full-stock battery compartments, though as always, we advise measuring carefully before ordering!

A high quality and compact PEQ box sized 11.1v Lithium Polymer Battery with 1300mAh of capacity, and a 20C discharge rating

If you're looking for a battery for a top-wired AK setup or an SMG-5K, this is the one! The Giant Power 7.4V 1300mAh 25C LiPo Slim Stick Battery is ideal for long, slim battery compartments, measuring approximately 18cm x 0.8cm x 1.6cm with a 5cm wire length, and is pre-wired to a Deans/T-plug connector. 

This 7.4V LiPo consists of 2 cells bound together into a single cell group, with a 25C continuous discharge rate and a capacity of 1300mAh. 

A 7.4v Lithium Polymer Battery designed for use in battery compartments with limited space for a thin, but long battery.

This 11.1v 1300mAh 15C LiPo Stick Battery is a high quality battery suitable for Airsoft and RC use. Being a single stick type this battery will fit into most Airsoft AEG hand guards or stocks and stock tubes.

Those of you looking for a battery with a truly large capacity, you've come to the right place! The battery is perfect for larger battery compartments such as SMG-5, G3, M16 and AK platforms with fixed stock battery compartments. The battery has a voltage of 7.4v, a capacity of 2800mAh and a continuous discharge rate of 25C with a maximum discharge rate of 50C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 13x1.1x4.2cm with a cable length of roughly 10cm.

A LiPo saddle battery designed to fit in handguards in replacement of the traditional 1600mAh NiMH blocks/saddles (G36 handguards etc).

If you're running a CYMA MOSFET-equipped AEP or the Novritsch SSE18 AEP, this is how you keep your electric pistol in the fight all day! The IPower 7.4V 680mAh 20c LiPo Battery For CYMA MOSFET AEPs is designed specifically for the CM.1xxS MOSFET-equipped AEP series and also fits the Novritsch SSE18, pre-wired to a mini-Deans connector and balance plug. Please note, this battery will NOT fit standard AEPs.

The battery can be charged and recharged using a standard LiPo balance charger, and the balance lead MUST be connected to ensure the battery is charged safely. We also recommend charging in a battery charging bag for maximum safety.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

This battery features a wider and flatter butterfly style configuration and while it won't fit in crane stocks it is perfect for larger areas such as AR36 handguards and full stock rifles. The battery has a voltage of 7.4v, a capacity of 1500mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however adaptors are available.

The battery consists of two cells working in tandem with each other, with each cell measuring 8.5x0.6x3.4cm with a cable length of roughly 9cm.

An 11.1v 2000mAh Li-Ion battery for Airsoft Electric Guns, which comes supplied in a Crane/Butterfly/Saddle configuration, meaning two rows of cells. This makes them very easy to place in awkard-to-fit spots such as Handguards and Crane Stocks, and will provide better Power Density that traditional LiPo batteries.

An ideal pack of 4 x AA batteries to power your accessories, from remotes to optics and more.

If you run a front-wired AEG with limited battery space, storing your battery in a PEQ-15 battery box could be the solution! This 7.4V 850mAh 20C LiPo battery from Electro River is designed to fit into cramped spaces and is the perfect size for use in a PEQ-15 battery box. The battery measures  5.5 x 3 x 1.5cm approximately, and the wire length between the cell group and connector is approximately 11cm.

The compact size of this battery makes it great for both Airsoft and any other electronics projects you have on the go, providing plenty of juice in a smaller form factor. The continuous discharge rate of this battery is 20C, and its peak is 60C, giving you a nice snappy response without overdoing things!

A pack of two AG3 LR41 batteries which are perfect for a range of Airsoft accessories and are ideal for keeping spare for Airsoft skirmishes to make sure you aren't taken out of the fight by a dead battery.

If you're looking for a battery for an AR36 or SMG-5 handguard, this is the one! The Giant Power 7.4V 1500mAh 25C LiPo Flat Nunchuck Battery is ideal for AEG handguards and fixed stock, measuring approximately 9.5cm x 2.8cm x 0.6cm (per cell) with a 5cm wire length, and is pre-wired to a Deans/T-plug connector.

This 7.4V LiPo consists of 2 cells configured as two cell groups, with a 25C continuous discharge rate and a capacity of 1500mAh.

An ultra-thin and lightweight battery, perfect for squeezing into even the tightest spots. This battery provides 1200mAh of power with a discharge rate of 30c. Being short and wide, this battery is perfect for PEQ boxes and solid stocks.

A blister pack of 10 x 1.5v Lithium button batteries that are commonly used in Airsoft sights, scopes and other accessories.

A singular CR2016 3V Lithium button battery which is commonly used for accessories such as sights and torches/lasers.

If you like to be at the cutting edge of battery technology when it comes to Airsoft, you're going to want to check this out! The Gens Ace 7.4V 25C 1000mAh Airsoft LiPo Battery - Mini-Tamiya is a slim LiPo battery intended for Airsoft buffer tube battery compartments, AK top covers and other cramped spaces requiring a single cell group. The discharge rate is 25C, giving you a snappy response without risking overspin in most setups, and the capacity is 1000mAh, meaning you might need two to get through a full game day.

Where this battery differs from the norm is its Smart Balance Connector which interfaces with the Gens Ace IMARS Mini Charger, communicating the battery type and current charge levels and immediately commencing optimal charging as soon as this "Smart Battery" is connected. Compared to legacy smart chargers, this saves loads of time but unfortunately means that this battery cannot be charged using a standard LiPo balance charger.

If you're after a flat nunchuck, aka butterfly battery for an AR-36 or M4A1 polymer handguard, the Giant Power 11.1v 1500mAh 25C LiPo Flat Nunchuck Battery is ideal. Designed for AR-36 and M4A1 handguards but capable of fitting in various unconventional battery compartments, this LiPo battery measures approximately 9.5cm x 2.9cm x 0.6cm (per cell), with a 5cm wire length, and is pre-wired to a Deans/T-plug battery connector. This battery can also be used in M16A1 or A2 fixed stocks, AK fixed stocks or any other platform with a decently sized fixed stock battery compartment. 

Please note: 11.1V LiPo batteries can cause pre-engagement in AEGs at UK power levels. This can result in internal damage. Please ensure you only use 11.1V batteries in AEGs designed for them (see "Specifications" on our AEG product pages for battery recommendations). 

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.