Airsoft 7.4v Li-Po Batteries

A compact LiPo Airsoft battery, designed to be used in tight awkward spaces, without compromising on overall capacity.

If you're looking for the very smallest of LiPo batteries, you've found it. Measuring 4x1.3x2cm, this battery can be used to power the FCU in the V12 engine, in addition to other HPA systems with a mini-JST type connector.

The battery has a voltage of 7.4v, a capacity of 250mAh and a discharge rate of 20C and features a cable length of roughly 10.5cm

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. Fitted with a deans connector for low resistance.

Suitable not only for Airsoft but for RC vehicles and toys too, this 7.4v 1550mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries wouldn't normally.

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space. 

A LiPo crane stock battery designed to fit in stocks and small spaces which other large batteries do not fit.

Those of you with limited battery space, this block battery is the one! The battery will fit near enough all AEG rifles and will be especially useful in rifles with PDW stocks. It has a voltage of 7.4v, a capacity of 2800mAh and a discharge 30C. The battery is connected to your AEG via the Deans connector, not to be confused with Mini-Tamiya connector, however, adaptors are available.

The battery measures 7.5x1.5x2.5cm with a cable length of roughly 4cm.

If you're looking for a tiny LiPo battery for your Novritsch SSE18 or CYMA CM.1xxS MOSFET equipped AEP, this is what you need. The Novritsch 7.4V 600mAh LiPo Battery measures approximately 7.3 x 1.5 x 1cm and is pre-wired with a Mini-Deans battery connector and a 3 port balance connector. 

As with other LiPo batteries, this battery should only ever be charged on a LiPo balance charger, preferably in a battery charging bag and should not be left on charge unattended under any circumstance.

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configurations with a Mini-Tamiya connector; an ideal setup for a Mini-Tamiya equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2x cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

Suitable not only for Airsoft but for RC vehicles and toys too. This Stick Battery is relatively large and excellent for ensuring you get a full day's play out of one charge, providing you're not too trigger happy.

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space. 

A LiPo battery with a universal electric pistol connection that will allow it to be used in pretty much every Airsoft Electric Pistol we can think of.

Those of you looking for a battery with a large capacity in a medium-sized block form factor, you've come to the right place! The battery is perfect for larger areas such as full-stocked SMG-5, G3, M16 and AK platforms, AR36 handguards and full-stock rifles. The battery has a voltage of 7.4v, a capacity of 2300mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 10x1.5x3.4cm with a cable length of roughly 10cm.

If you need a battery for your M4/AR-15 AEG Crane stock and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configuration with a Deans connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2 cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

An ultra-thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c. The battery is so thin it can fit into stock tubes and AK/MP5 AEG Battery compartments.

If you need a battery for your handguard or full stock battery compartment this should do the trick! The 7.4v 1600mAh 25C LiPo Battery from Giant Power is nice and compact, measuring 9.5x1.2x3cm approximately, making it great for handguard battery compartments in SMG-5 and AR36 AEGs and also an easy fit in M16 and AK full stocks.

The battery is pre-wired with a mini-Tamiya battery connector and is in block configuration, meaning both cells are bound together. The wire length between the battery itself and the connector is approximately 10cm and the continuous discharge rate is 25C, making this battery ideal both for Airsoft and any electronics hobby which requires a compact power source.

If you need a compact block battery for a handguard or fixed stock with limited space this should do the trick! The 7.4V 1500mAh 20C LiPo Block Battery from Electro River measures 8.5 x 1.2 x 3.4cm approximately with a wire length between the cell group and connector of approximately 9cm.

The pre-wired connector is the Deans/T-plug the continuous discharge rate is 20C and the maximum is 40C, making this battery great for both Airsoft applications and electronics hobbies.

A compact 7.4v two cell stick battery that is ideal for squeezing into small spaces like stock tubes, especially the battery spaces on Honey Badgers and compact weapons with an extending skeleton stock.

A 7.4v Lithium Polymer Battery designed for use in battery compartments with limited space for a thin, but long battery.

A humungous 7.4v LiPo battery in a Crane Stock / Nunchuck configuration which offers a massive 3000mAh capacity. If you want the biggest battery you can possibly squeeze into your replica, this is probably it!

Giant Power are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 35C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 7x1.5x3.4cm with a cable length of roughly 7.5cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery with a Mini-Tamiya connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a buffer tube battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 1.3cm x 1.5cm with approximately 9cm of wiring between the battery and connector

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery with a Deans connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a buffer tube battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 1.3cm x 1.5cm with approximately 9cm of wiring between the battery and connector. 

If you need an Airsoft battery that fits in almost anything and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo/ LiFe/NiMH Balance Charger, a Safe Charging Bag and an ASG 7.4V 1300mAh LiPo Battery in Crane configuration with a Mini-Tamiya connector; an ideal setup for Mini-Tamiya equipped AEGs and capable of fitting inside Crane stocks, fixed stocks and most handguards! If you have multiple different AEGs and you want a battery to fit them all, chances are this one will! 

The dimensions of the included battery are as follows: 10.1cm x 0.7cm x 2cm per cell group (2x cell groups on each battery) with approximately 10cm of wiring between the battery and connector. 

Compatible with: M4/AR-15 Crane Stock, M4/AR-15, SMG-5 & AK Fixed stock, AR-36 & SMG-5 handguards, Tokyo Marui SCAR-L/H NGRS stock, most M4/AR-15 buffer tubes. 

If you need a battery for your top wired AK or SMG-5K AEG and would rather get everything you need in one place, here it is! This bundle includes a LE-3 LiPo Balance Charger, a Safe Charging Bag and a Giant Power 7.4V 1300mAh LiPo Slim Stick Battery with a Mini-Tamiya connector; an ideal setup for a mini-Tamiya equipped top wired AK or SMG-5K AEG with a battery compartment inside the receiver.  

The dimensions of the included battery are as follows: 18.5cm x 1cm x 2cm with approximately 9.5cm of wiring between the battery and connector. 

If you are looking for the biggest battery you can fit in an M4/AR-15 buffer tube this would be it! The 7.4v 2000mAh 15C LiPo Stick Battery from Electro River just about fits in an M4/AR-15 buffer tube, though we recommend you do not fully collapse the stock once it is installed.

The battery measures 12.6 x1.6 x 2cm and should also be suitable for top-wired AK AEGs and will fit in almost all fixed stock battery compartments regardless of the platform. The wire length between the connector and cell group is approximately 9cm and the continuous discharge rate is 15C with a peak discharge rate of 30C.

If you need an Airsoft battery for an AEG with a fixed stock battery compartment and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and an Electro River 7.4v 2300mAh 20C LiPo Block Battery with a Mini-Tamiya connector; an ideal setup for Mini-Tamiya equipped AEGs with battery compartments within their fixed stocks. 

The dimensions of the included battery are as follows: 10cm x 1.5cm x 3.4cm with approximately 10cm of wiring between the battery and connector. 

Compatible with: M4/AR-15 Fixed stock, AK47/74 Fixed Stock, SMG-5 Fixed Stock, G3 Fixed Stock. 

If you need a slim stick battery for your ASG Scorpion, M4/AR-15 AEG buffer tube or top-wired AK AEG this will do the trick! The Electro River 7.4v 1200mAh 25C LiPo Stick Battery measures approximately 11.5 x 1.4 x 1.5cm which makes it perfect for rear wired M4 platforms with the standard buffer tube battery compartment, top wired AKs which house their battery beneath the top cover and SMG-5K platforms. The battery is pre-wired to a Deans connector and the length of wire between the cell group and the connector is approximately 9cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C and a maximum discharge rate of 50C, making it great for almost any Airsoft AEG and a perfect fit for the ASG Scorpion EVO 3A1, though make sure you measure before ordering!

If you're running a CYMA MOSFET-equipped AEP or the Novritsch SSE18 AEP, this is how you keep your electric pistol in the fight all day! The IPower 7.4V 680mAh 20c LiPo Battery For CYMA MOSFET AEPs is designed specifically for the CM.1xxS MOSFET-equipped AEP series and also fits the Novritsch SSE18, pre-wired to a mini-Deans connector and balance plug. Please note, this battery will NOT fit standard AEPs.

The battery can be charged and recharged using a standard LiPo balance charger, and the balance lead MUST be connected to ensure the battery is charged safely. We also recommend charging in a battery charging bag for maximum safety.

If you need a battery to fit into a tight place, Evolution Airsoft have you covered with the 7.4V 1100mAh 20C LiPo Stick Battery. This battery comes pre-wired with a Deans battery connector, also known as a "T-Plug" but is packaged with a Deans to mini-Tamiya adapter, meaning it can be used with almost any Airsoft AEG around.

The battery is a 2 cell 7.4V LiPo battery in stick configuration, meaning the cells are bound together into a single unit. The wire length between the battery and connector is approximately 10cm, the continuous discharge rate is 20C and the peak discharge rate is 40C. Whether you need a battery for your Airsoft gun or another electronics hobby which requires a compact power source, this Evolution Airsoft battery will do the trick!