All Airsoft Batteries

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya. 

Suitable not only for Airsoft but for RC vehicles and toys too, this  7.4v 2200mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries would normally not.

A large stick type LiPo battery, ideally suited to fitting inside an M4 or M16 type AEG stock tube.

A stick battery designed for most M4 stock tubes, solid stock sand some hand guards. An ideal starter LiPo which you should get half a days use out of at least from a slow charge.

VAPEX are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 30C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 10x1.2x3cm with a cable length of roughly 10cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

An ultra thin and lightweight battery, designed to squeeze into AK compartments. The battery provides 1100mAh of power with a discharge rate of 40C.

Popular VP Racing 8.4v 1600mAh stick battery often used within Airsoft AK AEGs, or other weapons that features a long, thin battery compartment.

An ultra thin, long LiPo crane stock battery. The battery is designed to fit into as little space as possible, taking up very little room allowing it to be fit into stocks and small battery compartments.

If you need a compact 11.1V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 11.1V 800mAh 20c LiPo Stick Battery should do the trick. This 11.1V 3S LiPo stick battery is fitted with a Deans battery connector and measures 10.4 x 1.7 x 1.9 cm with 4cm of wire length, making it suitable for upgraded Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A high quality 11.1V LiPo battery with a 1200mAh capacity and Dean connector, suitable for both Airsoft, RC and more.

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

A 7.4v 1450mAh LiPo stick battery suitable not only for Airsoft but for RC vehicles and toys too.

A compact block style battery from GFC Energy. The battery is comprised of 8 1.2V cells, providing 9.6V total voltage. This battery is ideally shaped for use inside an AR36 polymer handguard, a solid stock battery compartment in an SMG5, or a vertical grip battery box. This battery is wired to a mini-Tamiya connector, and can also be used for RC vehicles or other electronics hobbies.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. 

A LiPo crane stock battery designed to fit in stocks and small spaces which other large batteries do not fit.

A 23cm long 9.6v NiMH stick battery, ideally suited for powering top wired AEGs such as the AK47 and other weapons with a long and thin battery compartment.

An ultra thin and lightweight crane stock battery, perfect for squeezing into the ever more popular Airsoft crane stock.

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configurations with a Mini-Tamiya connector; an ideal setup for a Mini-Tamiya equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2x cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space. 

A high quality and ultra compact 7.4v Lithium Polymer Battery with 850mAh of capacity, wth a 30C discharge rating.

This LiPo battery from Gens Ace is designed to fit into compact and slim battery compartments, such as the M4/AR15 buffer tube and the AK47/74 top cover. The battery connects to your AEG via a mini-Tamiya connector and provides 1000mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8.5cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

If you are looking for a decently sized crane stock battery which should last all day, the VAPEX 7.4v 2200mAh 20C LiPo Crane Battery should do the trick! This battery is a 7.4V 2S LiPo in crane/nunchuck configuration, meaning the cells are separated into two individual units which makes the battery far easier to fit into unconventionally shaped battery compartments. The pre-wired connector is the common mini-Tamiya connector and the continuous discharge rate is 20C.

Each of the individual cell units measures 11x2.2x1.2cm approximately with a wire length of 9cm between each cell and the connector, meaning this should fit nicely in most crane stocks and many handguards and full-stock battery compartments, though as always, we advise measuring carefully before ordering!

An 11.1v crane stock LiPo Battery with an impressive 2600mAh capacity, designed to ensure that your Airsoft AEG can survive a whole day of Skirmishing.

An absolutely massive 11.1v LiPo 2600mAh 20c LiPo Battery in a Crane Stock configuration, with three cells which have individual dimensions of: 13.1cm x 1.98cm x 1.13cm. It has a 9cm cable with a Deans Connector on the end.

For those of you with some serious power requirements. This large LiPo battery is designed for crane stock use but may also be suitable for larger Airsoft hand guards too. This variant of the battery is fitted with a Deans connector.

A high quality and compact PEQ box sized 11.1v Lithium Polymer Battery with 1300mAh of capacity, and a 20C discharge rating

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

A 9.9V LiFe (Lithium Iron Phosphate) battery for Airsoft, RC and other hobbies. Ideally suited to sit in a handguard or stock, this battery provides a higher voltage (and rate of fire) over standard Airsoft batteries.

A four pack of AAA batteries rated at 1.5v - ideal for a wide range of Airsoft accessories and remotes as well as other hobbies like RC Cars, Boats and Planes.

A LiPo stick battery designed to fit in handguards in replacement of the traditional 1600mAh NiMH blocks (G36 handguards etc).