All Airsoft Batteries

A super thin triple crane stock 11.1v 1300mAh 25C LiPo that features a standard Tamiya connector and is made up of three individual thin cells, making it great for squeezing into awkward spaces.

An ideal battery for those who have very limited space or for those who have a front wired PEQ box style setup or RC cars. With a 1000mAh 30C discharge expect a good rate of fire but 2 or 3 are recommended for a full day of constant shooting.

If you're looking for spare batteries for your EMG JW3 AEP, this Specna Arms Gens Ace 7.4V 25C 620mAh G-Tech battery for AEPs is ideal! A 7.4V 2S LiPo with 620mAh capacity, this battery is pre-wired to a mini-Deans connector and a G-Tech balance plug. The G-Tech balance plug allows you to charge this battery on either a standard LiPo balance charger or the advanced G-Tech Charger from Gens Ace.

During our testing, we found this battery to be an incredibly tight fit in most AEPs, so we only recommend it for the EMG CM.138 JW3 AEP. Please note, if you do attempt to install this battery on other AEPs, it is likely you will damage the outer coating, which will invalidate your warranty. If you need to keep your JW3 AEP in the fight for longer, the Specna Arms Gens Ace 7.4V 25C 620mAh G-Tech battery for AEPs is the way to go!

A LiPo saddle battery designed to fit in handguards in replacement of the traditional 1600mAh NiMH blocks/saddles (G36 handguards etc).

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a mini-Tamiya connector and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

If you need a battery for a fixed stock or other large battery compartments this one should fit the bill! The 7.4V 1800mAh 20C Block LiPo Battery from Electro River is the perfect battery for full stocks found on M16, AK, SMG-5 and G3 Airsoft AEGs. The battery measures 10 x 1.2 x 3.5cm approximately with a wire length of around 9cm and is pre-wired to a mini-Tamiya battery connector.

The battery is a 7.4V 2-cell battery in block configuration with a continuous discharge rate of 20C and a maximum discharge rate of 40C, making it great for almost any Airsoft AEG, though make sure you measure before ordering!

An 11.1v 2000mAh Li-Ion battery for Airsoft Electric Guns, which comes supplied in a Crane/Butterfly/Saddle configuration, meaning two rows of cells. This makes them very easy to place in awkard-to-fit spots such as Handguards and Crane Stocks, and will provide better Power Density that traditional LiPo batteries.

Those of you looking for a battery with a truly large capacity, you've come to the right place! The battery is perfect for larger battery compartments such as SMG-5, G3, M16 and AK platforms with fixed stock battery compartments. The battery has a voltage of 7.4v, a capacity of 2800mAh and a continuous discharge rate of 25C with a maximum discharge rate of 50C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 13x1.1x4.2cm with a cable length of roughly 10cm.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

A pack of two AG3 LR41 batteries which are perfect for a range of Airsoft accessories and are ideal for keeping spare for Airsoft skirmishes to make sure you aren't taken out of the fight by a dead battery.

An ideal pack of 4 x AA batteries to power your accessories, from remotes to optics and more.

A singular CR2016 3V Lithium button battery which is commonly used for accessories such as sights and torches/lasers.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a Deans connector (aka a T-Plug) and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A blister pack of 10 x 1.5v Lithium button batteries that are commonly used in Airsoft sights, scopes and other accessories.

If you like to be at the cutting edge of battery technology when it comes to Airsoft, you're going to want to check this out! The Gens Ace 7.4V 25C 1000mAh Airsoft LiPo Battery - Mini-Tamiya is a slim LiPo battery intended for Airsoft buffer tube battery compartments, AK top covers and other cramped spaces requiring a single cell group. The discharge rate is 25C, giving you a snappy response without risking overspin in most setups, and the capacity is 1000mAh, meaning you might need two to get through a full game day. 

Where this battery differs from the norm is its Smart Balance Connector which interfaces with the Gens Ace IMARS Mini Charger, communicating the battery type and current charge levels and immediately commencing optimal charging as soon as this "Smart Battery" is connected. Compared to legacy smart chargers, this saves loads of time but unfortunately means that this battery cannot be charged using a standard LiPo balance charger. 

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

If you need a battery for your AR36 AEG or polymer handguard equipped M4/AR-15 AEG this one will do the trick! The 7.4v 1800mAh 20C LiPo Flat Nunchuck Battery from Electro River is a flat nunchuck style battery, also known as a "butterfly" configuration. Unlike other nunchuck batteries, this won't inside a crane stock and is more suitable for large polymer handguards such as those found on AR36 and M4A1 AEGs and will also fit nicely in most fixed rifle stocks.

The battery itself is a 2-cell 7.4V LiPo with a wire length of approximately 9cm between the cell groups and the connector, and each of the two cell groups measures 10 x 0.6 x 3.5cm approximately. The pre-wired connector is the common mini-Tamiya type and the continuous discharge rate is 20C, with a maximum discharge rate of 40C.

A strip of two LR66 / LR626 batteries of a 1.5V individual voltage, perfect for any accessories that run this strange size of watch battery.

If you need a slim stick battery for your ASG Scorpion, M4/AR-15 AEG buffer tube or top-wired AK AEG this will do the trick! The Gen's Ace 7.4v 1500mAh 25C LiPo Stick Battery measures approximately 12x1.5x1.6cm which makes it perfect for rear wired M4 platforms with the standard buffer tube battery compartment, top wired AKs which house their battery beneath the top cover and SMG-5K platforms. The battery is pre-wired to a Mini-Tamiya connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEG and a perfect fit for the ASG Scorpion EVO 3A1, though make sure you measure before ordering!

This battery features a wider and flatter butterfly style configuration and while it won't fit in crane stocks it is perfect for larger areas such as AR36 handguards and full stock rifles. The battery has a voltage of 7.4v, a capacity of 1500mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however adaptors are available.

The battery consists of two cells working in tandem with each other, with each cell measuring 8.5x0.6x3.4cm with a cable length of roughly 9cm.

The perfect battery to give you enough juice for a full weekend of Airsoft milsim action. 9.6v and 4600mAh of power. Commonly used within M249, M16 and M14 variants.

A LiPo Crane Stock battery designed to fit in stocks and small spaces which other large batteries do not fit. The battery is also know as a Nunchuck battery, with the cells connected via the wires allowing them to be placed down the side of barrels or in an M4 Crane Stock.

A LiPo battery for Airsoft, RC Cars and many other hobbies, which comes in a Crane Stock/Butterfly configuration with a Deans connector. This battery is perfect for rear wired crane stocks and front wired handguards.

A Standard powered Airsoft Battery, designed to be used in almost all Airsoft AEG weapons with a mini-Tamiya connector, providing the perfect amount of power for most Airsoft Weapons. 

An 11.1v 1450mAh 30C LiPo in a stick configuration, which features a Deans connector instead of the standard small Tamiya.

A High voltage Airsoft LiPo Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

A battery designed and built by NUPROL specifically for Airsoft Skirmishers as part of their POWER range of Batteries, the battery is constructed from individual cells which are held together by durable shrink wrapping, and feature a mini-Tamiya connector to connect it to your weapon.

A LiPo stick battery for Airsoft, RC Cars and many other hobbies which comes as a stick configuration with a Deans connector. This battery is perfect for top-wired receivers and rear wired buffer tubes.

A pack of 2 3V Lithium CR123A batteries which are suitable for a wide range of Airsoft red dot sights, tactical flashlights and other Airsoft/photography accessories.