LiPo Batteries

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a Deans connector (aka a T-Plug) and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A compact 7.4v two cell stick battery that is ideal for squeezing into small spaces like stock tubes, especially the battery spaces on Honey Badgers and compact weapons with an extending skeleton stock.

An ideal battery for those who have very limited space or for those who have a front wired PEQ box style setup or RC cars. With a 1000mAh 30C discharge expect a good rate of fire but 2 or 3 are recommended for a full day of constant shooting.

If you are looking for a decently sized crane stock battery which should last all day, the VAPEX 7.4v 2200mAh 20C LiPo Crane Battery should do the trick! This battery is a 7.4V 2S LiPo in crane/nunchuck configuration, meaning the cells are separated into two individual units which makes the battery far easier to fit into unconventionally shaped battery compartments. The pre-wired connector is the common mini-Tamiya connector and the continuous discharge rate is 20C.

Each of the individual cell units measures 11x2.2x1.2cm approximately with a wire length of 9cm between each cell and the connector, meaning this should fit nicely in most crane stocks and many handguards and full-stock battery compartments, though as always, we advise measuring carefully before ordering!

If you're looking for a battery for a top-wired AK setup or an SMG-5K, this is the one! The Giant Power 7.4V 1300mAh 25C LiPo Slim Stick Battery is ideal for long, slim battery compartments, measuring approximately 18cm x 0.8cm x 1.6cm with a 5cm wire length, and is pre-wired to a Deans/T-plug connector. 

This 7.4V LiPo consists of 2 cells bound together into a single cell group, with a 25C continuous discharge rate and a capacity of 1300mAh. 

A 7.4v Lithium Polymer Battery designed for use in battery compartments with limited space for a thin, but long battery.

Those of you looking for a battery with a truly large capacity, you've come to the right place! The battery is perfect for larger battery compartments such as SMG-5, G3, M16 and AK platforms with fixed stock battery compartments. The battery has a voltage of 7.4v, a capacity of 2800mAh and a continuous discharge rate of 25C with a maximum discharge rate of 50C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 13x1.1x4.2cm with a cable length of roughly 10cm.

A LiPo saddle battery designed to fit in handguards in replacement of the traditional 1600mAh NiMH blocks/saddles (G36 handguards etc).

If you're running a CYMA MOSFET-equipped AEP or the Novritsch SSE18 AEP, this is how you keep your electric pistol in the fight all day! The IPower 7.4V 680mAh 20c LiPo Battery For CYMA MOSFET AEPs is designed specifically for the CM.1xxS MOSFET-equipped AEP series and also fits the Novritsch SSE18, pre-wired to a mini-Deans connector and balance plug. Please note, this battery will NOT fit standard AEPs.

The battery can be charged and recharged using a standard LiPo balance charger, and the balance lead MUST be connected to ensure the battery is charged safely. We also recommend charging in a battery charging bag for maximum safety.

This battery features a wider and flatter butterfly style configuration and while it won't fit in crane stocks it is perfect for larger areas such as AR36 handguards and full stock rifles. The battery has a voltage of 7.4v, a capacity of 1500mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however adaptors are available.

The battery consists of two cells working in tandem with each other, with each cell measuring 8.5x0.6x3.4cm with a cable length of roughly 9cm.

If you run a front-wired AEG with limited battery space, storing your battery in a PEQ-15 battery box could be the solution! This 7.4V 850mAh 20C LiPo battery from Electro River is designed to fit into cramped spaces and is the perfect size for use in a PEQ-15 battery box. The battery measures  5.5 x 3 x 1.5cm approximately, and the wire length between the cell group and connector is approximately 11cm.

The compact size of this battery makes it great for both Airsoft and any other electronics projects you have on the go, providing plenty of juice in a smaller form factor. The continuous discharge rate of this battery is 20C, and its peak is 60C, giving you a nice snappy response without overdoing things!

If you're looking for a battery for an AR36 or SMG-5 handguard, this is the one! The Giant Power 7.4V 1500mAh 25C LiPo Flat Nunchuck Battery is ideal for AEG handguards and fixed stock, measuring approximately 9.5cm x 2.8cm x 0.6cm (per cell) with a 5cm wire length, and is pre-wired to a Deans/T-plug connector.

This 7.4V LiPo consists of 2 cells configured as two cell groups, with a 25C continuous discharge rate and a capacity of 1500mAh.

An ultra-thin and lightweight battery, perfect for squeezing into even the tightest spots. This battery provides 1200mAh of power with a discharge rate of 30c. Being short and wide, this battery is perfect for PEQ boxes and solid stocks.

If you like to be at the cutting edge of battery technology when it comes to Airsoft, you're going to want to check this out! The Gens Ace 7.4V 25C 1000mAh Airsoft LiPo Battery - Mini-Tamiya is a slim LiPo battery intended for Airsoft buffer tube battery compartments, AK top covers and other cramped spaces requiring a single cell group. The discharge rate is 25C, giving you a snappy response without risking overspin in most setups, and the capacity is 1000mAh, meaning you might need two to get through a full game day.

Where this battery differs from the norm is its Smart Balance Connector which interfaces with the Gens Ace IMARS Mini Charger, communicating the battery type and current charge levels and immediately commencing optimal charging as soon as this "Smart Battery" is connected. Compared to legacy smart chargers, this saves loads of time but unfortunately means that this battery cannot be charged using a standard LiPo balance charger.

If you need a slim stick battery for your ASG Scorpion, M4/AR-15 AEG buffer tube or top-wired AK AEG this will do the trick! The Gen's Ace 7.4v 1500mAh 25C LiPo Stick Battery measures approximately 12x1.5x1.6cm which makes it perfect for rear wired M4 platforms with the standard buffer tube battery compartment, top wired AKs which house their battery beneath the top cover and SMG-5K platforms. The battery is pre-wired to a Mini-Tamiya connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEG and a perfect fit for the ASG Scorpion EVO 3A1, though make sure you measure before ordering!

If you need a super-tiny battery for a PDW stock, EMG Autobot Speedloader or other cramped battery compartment, check this out! The Giant Power 7.4v 560mAh 25c LiPo PDW/Autobot Stick Battery measures a mere 7.5cm x 1.1cm x 1.5cm approximately, with 5cm of wire length, pre-wired to a Deans/T-plug battery connector. 

Being super-duper small, this battery will fit neatly where others won't, including in L85 platforms wired to the pistol grip (A3 & AFV), M4/AR-15 platforms with PDW stocks and other tight battery compartments. It's also a perfect fit in EMG's Autobot Speed Loader!

A Standard powered Airsoft Battery, designed to be used in almost all Airsoft AEG weapons with a mini-Tamiya connector, providing the perfect amount of power for most Airsoft Weapons. 

A LiPo stick battery for Airsoft, RC Cars and many other hobbies which comes as a stick configuration with a Deans connector. This battery is perfect for top-wired receivers and rear wired buffer tubes.

A 7.4v LiPo Battery for Airsoft Electric Guns, specifically the Specna Arms PDW range and other replicas with a tight/compact Battery Compartment. The Battery has a capacity of 600mAh, and a discharge rate of 20/40C. The compact size of the Battery makes it ideal for PDW Stocks, Pistol Grips, PEQ Boxes and other tight battery spaces.

If you want the biggest stick battery you can squeeze into your M4/AR-15 buffer tube, this is probably it! The Specna Arms 7.4v 2000mAh 15/30c LiPo Stick Battery is pre-wired to a mini-Tamiya battery connector and designed for slim and long battery compartments. The battery is a 7.4V LiPo with a capacity of 2000mAh, continuous discharge rate of 15C and maximum discharge rate of 30C.

The battery measures 12.3 x 1.6 x 1.8cm approximately and should fit into most M4/AR-15 buffer tubes, though some with less space inside may require that you leave the stock in an extended position. The wire between the cell group and connector is approximately 10cm, giving you plenty of flexibility to fit the battery where you need it. As always, measure up before you buy!

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A 7.4v 1450mAh LiPo stick battery with Deans connectors, suitable for Airsoft in addition to other application such as RC vehicles and toys too.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards  and comes fitted with Deans connectors instead of the standard Tamiya for upgraded Airsoft Guns.

A high quality 1300mAh 7.4V LiPo battery suitable for Airsoft and RC use, coming fitted with an upgraded Deans Connector rather than the standard Mini Tamiya.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too, and is designed to give you a high output for fast rate of fire and trigger response for roughly half a day dependent on trigger happiness.

If you need a battery for your M4/AR-15 buffer tube or your top-wired AK AEG this should be perfect! The VAPEX 7.4v 1300mAh 20C LiPo Stick Battery measures 14 x 1.2 x 1.8cm approximately with a wire length of 9cm, making it a good fit in rear wired M4s with a buffer tube battery compartment, SMG-5K AEGs or AK AEGs in the top-wired configuration.

The pre-installed battery connector is the common mini-Tamiya type and the battery has a discharge rate of 20C, making it ideal for Airsoft applications but also useful for those needing a compact power source for electronics or R/C projects.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too, this variant of the battery is fitted with a Deans connector for upgraded Airsoft Gun connectors, rather than the standard Mini Tamiya.

A high quality 1300mAh 7.4V LiPo battery suitable for Airsoft and RC use - perfect for fitting down stock tubes and areas with a small amount of space.

VP Racing are well known for their high quality and high performance batteries with this one being a crane form factor. The battery has a voltage of 7.4v, has a capacity of 1450mAh and a discharge rate of 25C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery consists of two cells working in tandem, with each cell measuring 13x0.7x2cm each with a cable length of roughly 7.5cm of wire. The battery should fit in crane stock battery compartments such as M4s and some handguards and full stocks, but remember to measure up before hand!

If you need a slim stick battery for your AK or SMG-5 AEG this will do the trick! The Giant Power 7.4v 1300mAh 25C LiPo Stick Battery measures approximately 18.5x1x2cm, which makes it perfect for longer battery compartments such as AK dust covers and SMG-5 platforms. The battery is pre-wired to a Mini-Tamiya connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEGs, RC cars and more!