Gate PicoSSR 3 AEG Micro Mosfet Unit

Gate
Code: PSSR3
18.49
  • Fits Any AEG
  • Ultra Compact
  • Protects Trigger Contact

An ultra compact Generation 3 MOSFET built to be as compact as possible, requiring the smallest amount space possible, and is water resistant. 

Full description

Description

This MOSFET is designed to achieve a higher rate of fire and trigger response, as well as protects the mechanical trigger contacts by directly bypassing the contacts and going straight to the motor. The unit itself is so compact that it can be fit in any Airsoft AEG, allowing you to wire the unit in down buffer tubes and in tight hand guards. The package comes with everything you need to connect up the unit, with spare wires for different trigger setups. This is perfect for those Airsoft Players who want the absolute best out of their weapon, adding a features which improve the performance of Rifles.

  • Battery Support: 7.2v LiPo, 11.1v LiPo, 12.8v LiFe, 8.4v NiMh, 9.6v NiMh
  • Operating Ranges: 3v - 13v
  • User Guide: picossr3_en.pdf

Features

  • 12 Months Warranty
  • Ultra Compact Design
  • 3rd Generation Mosfets
  • Trigger Protecting MOSFET
  • Smaller and more compact than over units on the market
  • Increases the ROF of your AEG
  • Provides a better Trigger Responce
  • Resistant to Water Immersion
  • Kit comes with all required parts
  • Fits in any Airsoft AEG
  •  

Package Includes

  • PicoSSR 3 AEG Micro Mosfet Unit
  • Single Signal Wire for Trigger Contacts x2

Special Instructions

Should you need any help installing the MOSFET please feel free to call our workshop on: 01484 644709.

Do not hold the Soldering Iron on the Unit for more than 3 seconds, as this will cause permanent heat damage to the MOSFET unit.

Please note that the warranty covers the unit from defects, not improper installation. Please read all user guides before installing.

Please remember when installing the device to ensure your AEG is clear before use,

Ensure that when wiring up the device the Positive and Negative battery terminals are the correct way around as this will cause immediate damage to the unit.

For warranty related issues please visit: http://gatee.eu/technical-support/warranty

Version Comparisons

GATE Mosfet comparison chart

Specification

General

Parts & Accessories Type
Internal Parts
Internal Part Type
MOSFET
Patrol Base - Warning Icon
Warnings
Patrol Base - Warning Icon
Parts Fitting

Construction

Colour Wheel Greyscale
Item Colour
Black
Construction Icon
Construction
Ultra Compact Circuit Board

Part Specific

Part for Power Source Type
Electric

Electric Part Specific

Gearbox Version Compatibility Variant
Most Airsoft AEG

Size guide

Parts Fitting

Upgrades and Downgrades should only be undertaken by experienced players, or Airsoft Technicians. Please note, changing any internal parts of a weapon voids its warranty unless done in-house by our staff. 

Please ensure that when fitting parts the part purchased is the correct part, as once a part has been fitted we cannot accept return.

We do know that players love to tinker, so we're here to give you help should you require it, and if needed you can get in touch with our workshop for more help!

Unique Parts

Please note that some parts may be unique to a specific brand of weapon. For example: Parts for an ASG M4A1 may not fit an ICS M4A1.

Parts from the same brand typically have a high chance of fitting, though be warned, some replicas use unique parts, so please ensure the part will fit before you attempt to fit it.

If you require help with fitting any parts feel free to get in touch with us via our Contact Us Page.