Refine results
Refine by
Viewing 7 of 7.
grid
list
0.99
  • Large Tamiya connector
  • Gun end or Battery end
  • Useful spares for a tech

The Patrol Base Large Tamiya Connector is an essential spare to have if you are the techy type of Airsofter who cannot resist customising their kit, but could also be useful for anyone who participates in RC hobbies. The set includes the connector and the outer plastic shroud, and is available as either a set to mount to your gun (Gun end) or a set to mount to your battery (Battery end).

0.99
  • Large Tamiya connector
  • Gun end or Battery end
  • Useful spares for a tech

The Patrol Base Large Tamiya Connector is an essential spare to have if you are the techy type of Airsofter who cannot resist customising their kit, but could also be useful for anyone who participates in RC hobbies. The set includes the connector and the outer plastic shroud, and is available as either a set to mount to your gun (Gun end) or a set to mount to your battery (Battery end).

3.99
  • All 9cm Long
  • Various Colours
  • Set Of 21 Tubes

A heat-shrink kit designed to give you all the heat-shrink you'll need when working on a project gun or replacing wires. The heat-shrink is constructed from PVC, and shrinks in size when heated, designed to protect wires and other electrical components.

14.49
  • Silicon Coated
  • 2 Metres Length
  • Highly Conductive

Super conductive and easy to route throughout your gearbox and rest of your Airsoft AEG.

35.99
  • Low Resistance
  • Switch Assembly
  • Mini Tamiya Plug

A complete Switch Assembly for a variety of AEGs, which includes Low Resistance Wiring with either a Mini Tamiya or Deans Connector on the end.

71.49
  • Programmable Trigger
  • 'Speed Trigger' Included
  • For Version 2 Rear Wired

A drop-in trigger, ETU & MOSFET for Version 2 compatible rear-wired Airsoft replicas, which includes features like a programmable trigger, low battery cutoff, shot sensor and comes included with a vertical 'speed trigger'.

100.99
  • Complete pre-wired ETU and MOSFET
  • For Airsoft AEGs with Version 2 gearbox
  • Provides battery protection and programmable fire controls

So you want a MOSFET in your Airsoft gun, but you aren't a fan of soldering? G&G have just the thing! The ETU 2.0 and MOSFET 3.0 from G&G come as a pre-wired set which can be (relatively) easily installed into any version 2 AEG gearbox, with no need to solder! The set comes wired for rear wired AEGs and includes a mini-Tamiya battery connector and automotive fuse. This MOSFET is the same as that used in the G&G advanced series, and provides low voltage cut-off to protect your battery, and allows for programmable fire modes using the controls on the AEG itself!

Got some burnt out Wiring to replace? Want to up-rate some older wiring in preparation for a higher voltage battery? Just feel like making your internals all pretty and uniform? Grab yourself some Silver Wiring today to ensure you have the most conductive circuitry possible.