Airsoft 11.1v Li-Po Batteries

A high quality 11.1V LiPo battery with a 1200mAh capacity and Dean connector, suitable for both Airsoft, RC and more.

A high powered Airsoft Battery, designed to be used in highly tuned top-end gearbox. The battery comes in a 'stick' configuration, with two adjoined cells in one block, allowing the battery to be squeezed into even the tightest of buffer tubes. 

An 11.1v 1200mAh 20c LiPo Battery with a Deans Connector in a Stick configuration, making it ideal for Solid Stocks and some rear wired Buffer Tubes. It has the following dimensions with a 9cm cable: 2cm x 1.63cm x 13cm.

An 11.1v 1200mAh 20c LiPo Battery in a Slim Stick configuration, complete with a Deans Connector. It has total dimension of: 1.35cm x 1.62cm x 18.5cm and is perfect for up-rated guns and rifles with a high power draw such as DMRs and high rate of fire setups, and other replicas that require a Stick Battery down the Receiver, such as AK/UMP models.

A high voltage Airsoft Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

If you're looking for an 11.1V LiPo well suited to top wired AK platforms, this is the one! The Gens Ace 11.1V 1400mAh 25C LiPo Slim Stick Battery is pre-wired to a Deans connector and balance plug, measuring approximately 19.5 x 1.4 x 1.8 cm. This 3S 11.1V LiPo battery has a 25C discharge rating and 1400mAh capacity, making it well suited to AEGs with electronic trigger units or other high power-draw needs.

This battery is ideal for top-wired AK AEGs and SMG-5K platforms with a battery compartment inside the receiver, being slimmer than standard buffer tube style stick batteries. If you want to take full advantage of the lengthy battery compartment in your top-wired AK or SMG-5K, the Gens Ace 11.1V 1400mAh 25C LiPo Slim Stick Battery is the way to go!

A super thin triple crane stock 11.1v 1300mAh 25C LiPo that features a standard Tamiya connector and is made up of three individual thin cells, making it great for squeezing into awkward spaces.

An 11.1v 1300mAh 20c LiPo Battery with a Deans Connector in a Stick configuration, making it ideal for Solid Stocks and some rear wired Buffer Tubes. It has the following dimensions with a 9cm cable: 2cm x 1.62cm x 12.8cm.

This 11.1v 1300mAh 15C LiPo Stick Battery is a high quality battery suitable for Airsoft and RC use. Being a single stick type this battery will fit into most Airsoft AEG hand guards or stocks and stock tubes.

If you're running an upgraded or MOSFET-equipped AEG, this Gens Ace 11.1v 25C 1500mAh LiPo Battery may be just what you need to power it. This Lithium Polymer (LiPo) battery is pre-wired to a Deans/T-Plug battery connector and consists of 3 cell groups wired in nun-chuck/crane/butterfly configuration. The wire length between the cells and connector is approximately 8cm and each of the 3 cells measures approximately 0.8 x 1.6 x 13 cm. 

Not all Airsoft AEGs are capable of running an 11.1V LiPo without causing damage, if you are unsure check the recommended battery section of the your gun's product description. LiPo batteries require balance charging, meaning this battery MUST be charged using a LiPo balance charger with the balance port connected. We recommend using a battery charging bag for storage and charging, and to never leave an Airsoft battery on charge while unattended. 

A high quality LiPo battery, suitable for both Airsoft and RC made by Giant Power. This battery is 11.1v with a 25C discharge rate, making it well suited to enhanced replicas such as DMR AEGs and LMGs which require more power.

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries.

A compact yet high output LiPo battery designed for most M4 stock tubes, solid stocks and some hand guards.