LiPo Batteries

A LiPo Crane Stock battery designed to fit in stocks and small spaces which other large batteries do not fit. The battery is also know as a Nunchuck battery, with the cells connected via the wires allowing them to be placed down the side of barrels or in an M4 Crane Stock.

A ultra thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c, giving it a 20w output.

A Standard powered Airsoft Battery, designed to be used in almost all Airsoft AEG weapons with a mini-Tamiya connector, providing the perfect amount of power for most Airsoft Weapons. 

A High voltage Airsoft LiPo Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

High quality WE 11.1v 1450mAh 30C LiPo Stick Battery, provides great battery life and fits most battery compartments. The 30C rating means the battery discharges quicker to give a higher rate of fire and better trigger response.

If you want the biggest stick battery you can squeeze into your M4/AR-15 buffer tube, this is probably it! The Specna Arms 7.4v 2000mAh 15/30c LiPo Stick Battery is pre-wired to a mini-Tamiya battery connector and designed for slim and long battery compartments. The battery is a 7.4V LiPo with a capacity of 2000mAh, continuous discharge rate of 15C and maximum discharge rate of 30C.

The battery measures 12.3 x 1.6 x 1.8cm approximately and should fit into most M4/AR-15 buffer tubes, though some with less space inside may require that you leave the stock in an extended position. The wire between the cell group and connector is approximately 10cm, giving you plenty of flexibility to fit the battery where you need it. As always, measure up before you buy!

VP Racing are well known for their high quality and high performance batteries with this one being a crane form factor. The battery has a voltage of 7.4v, has a capacity of 1450mAh and a discharge rate of 25C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery consists of two cells working in tandem, with each cell measuring 13x0.7x2cm each with a cable length of roughly 7.5cm of wire. The battery should fit in crane stock battery compartments such as M4s and some handguards and full stocks, but remember to measure up before hand!

A LiPo battery for Airsoft Electric Guns which has been designed to output a high power for fast and consistent trigger response and high rate of fire for up to 3 quarters of a day on a slow charge. 

A LiPo Battery for Airsoft Electric Guns, with an 11.1v rating and 600mAh capacity. This compact 11.1v LiPo is ideal for PDWs and Airsoft Guns with a small battery space (specifically the Specna Arms PDWs), and features a Mini Tamiya Connector to connect to your AEG. If you have an Airsoft Gun that needs an 11.1v Battery, and has a tight battery compartment, then this is the ideal LiPo for you.

A high quality 1300mAh 7.4V LiPo battery suitable for Airsoft and RC use, coming fitted with an upgraded Deans Connector rather than the standard Mini Tamiya.

An ultra thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c, giving it a 20w output. 

A 7.4v 1450mAh LiPo stick battery with Deans connectors, suitable for Airsoft in addition to other application such as RC vehicles and toys too.

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries. 

A high quality 11.1V LiPo battery with a 1200mAh capacity, suitable for both Airsoft and RC use.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards  and comes fitted with Deans connectors instead of the standard Tamiya for upgraded Airsoft Guns.

If you need spare batteries for your AEP with a bit more oomph than the standard NiMh, this will do it! The IPower 7.4v 680mAh 20c LiPo Micro Battery is designed for CYMA CM.1xx series AEPs, fitted with a standard AEP connector and sized to fit AEP battery compartments. This battery is NOT compatible with AEP SMGs like the VZ61, MAC-10 or SMG-7 or the MOSFET-equipped CM.1xxS series. 

This battery can be charged via its balance port using a LiPo balance charger, and as always, we recommend never leaving a LiPo on charge unattended and always using a LiPo charging bag.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. Fitted with a deans connector for low resistance.

A super thin, triple cell crane stock styled 11.1v LiPo battery, featuring a small Tamiya connector for easy use.

If you need a battery for your M4/AR-15 buffer tube or your top-wired AK AEG this should be perfect! The VAPEX 7.4v 1300mAh 20C LiPo Stick Battery measures 14 x 1.2 x 1.8cm approximately with a wire length of 9cm, making it a good fit in rear wired M4s with a buffer tube battery compartment, SMG-5K AEGs or AK AEGs in the top-wired configuration.

The pre-installed battery connector is the common mini-Tamiya type and the battery has a discharge rate of 20C, making it ideal for Airsoft applications but also useful for those needing a compact power source for electronics or R/C projects.

A 7.4v 1500mAh LiPo battery that provides a 20c discharge rate and is highly compact, making it ideal for external PEQ battery boxes and tight, square spaces.

A large stick type battery, designed to output a high power for fast trigger response and rate of fire for up to three quarters of a day on a slow charge.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya. 

A high quality 1300mAh 11.1V LiPo battery suitable for Airsoft and RC use. A single stick type battery that will fit into most Airsoft AEG hand guards or stocks and stock tubes.

An 11.1v 1300mAh 20c LiPo Battery in a PEQ Box configuration, which makes it perfect for hiding inside a PEQ Box. It has a 9cm cable with a Deans Connector on the end, and total dimensions of: 1.65cm x 4.15cm x 6.6cm.

Suitable not only for Airsoft but for RC vehicles and toys too, this  7.4v 2200mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries would normally not.

A large stick type LiPo battery, ideally suited to fitting inside an M4 or M16 type AEG stock tube.

An ultra thin, long LiPo crane stock battery. The battery is designed to fit into as little space as possible, taking up very little room allowing it to be fit into stocks and small battery compartments.

An ultra thin and lightweight battery, designed to squeeze into AK compartments. The battery provides 1100mAh of power with a discharge rate of 40C.

A stick battery designed for most M4 stock tubes, solid stock sand some hand guards. An ideal starter LiPo which you should get half a days use out of at least from a slow charge.