Airsoft 7.4v Li-Po Batteries

A LiPo stock tube battery designed to fit in buffer tubes and small spaces which other large batteries do not fit.

Need a full battery and charger setup for your AEG? Get both at once with the Specna Arms Set EASY Charger with a 7.4V 1000mAh Battery! This package has everything you need to get started. The balance charger ensures that all your battery's cells are charged equally; it also works for 11.1V batteries.

7.4V batteries are ideal for most Airsoft AEGs, as they are the standard voltage for Airsoft batteries. However, some Airsoft platforms are built specifically for 11.1V; if you have one of these replicas, check out the 11.1V EASY Charger Set!

A LiPo Crane Stock battery designed to fit in stocks and small spaces which other large batteries do not fit. The battery is also know as a Nunchuck battery, with the cells connected via the wires allowing them to be placed down the side of barrels or in an M4 Crane Stock.

A 7.4v LiPo Battery for Airsoft Electric Guns, specifically the Specna Arms PDW range and other replicas with a tight/compact Battery Compartment. The Battery has a capacity of 600mAh, and a discharge rate of 20/40C. The compact size of the Battery makes it ideal for PDW Stocks, Pistol Grips, PEQ Boxes and other tight battery spaces.

If you're running a CYMA MOSFET-equipped AEP or the Novritsch SSE18 AEP, this is how you keep your electric pistol in the fight all day! The IPower 7.4V 680mAh 20c LiPo Battery For CYMA MOSFET AEPs is designed specifically for the CM.1xxS MOSFET-equipped AEP series and also fits the Novritsch SSE18, pre-wired to a mini-Deans connector and balance plug. Please note, this battery will NOT fit standard AEPs.

The battery can be charged and recharged using a standard LiPo balance charger, and the balance lead MUST be connected to ensure the battery is charged safely. We also recommend charging in a battery charging bag for maximum safety.

If you need a super-tiny battery for a PDW stock or other cramped battery compartment, check this out! The Matrix 7.4V 600mAh LiPo PDW Stick Battery (Deans) measures a mere 7.5cm x 1.25cm x 1.7cm approximately, with 10cm of wire length, pre-wired to a Deans/T-plug battery connector. 

Being super-duper small, this battery will fit neatly where others won't, including in L85 platforms wired to the pistol grip (A3 & AFV), M4/AR-15 platforms with PDW stocks and other tight battery compartments. 

A stick 7.4v 1100mAh LiPo designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries, intended to allow Airsofters to get the best possible performance from their Airsoft Electric Guns.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a Deans connector (aka a T-Plug) and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A 7.4v rated LiPo Battery for Airsoft Electric Guns, specifically ones that need a compact battery for a small space, such as PDW Stocks and Pistol Grips. The Battery has a 600mAh Capacity and a 20/40C Discharge Rate, as well as having a Mini Tamiya Connector to make it compatible with a huge range of Airsoft Guns. If you need a compact 7.4v LiPo for a Specna Arms PDW or other Airsoft Gun with a tight battery space, then this is the ideal choice.

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space.

If you're looking for a battery for an AR36 or SMG-5 handguard, this is the one! The Giant Power 7.4V 1500mAh 25C LiPo Flat Nunchuck Battery is ideal for AEG handguards and fixed stock, measuring approximately 9.5cm x 2.8cm x 0.6cm (per cell) with a 5cm wire length, and is pre-wired to a Deans/T-plug connector.

This 7.4V LiPo consists of 2 cells configured as two cell groups, with a 25C continuous discharge rate and a capacity of 1500mAh.

If you want the biggest stick battery you can squeeze into your M4/AR-15 buffer tube, this is probably it! The Specna Arms 7.4v 2000mAh 15/30c LiPo Stick Battery is pre-wired to a mini-Tamiya battery connector and designed for slim and long battery compartments. The battery is a 7.4V LiPo with a capacity of 2000mAh, continuous discharge rate of 15C and maximum discharge rate of 30C.

The battery measures 12.3 x 1.6 x 1.8cm approximately and should fit into most M4/AR-15 buffer tubes, though some with less space inside may require that you leave the stock in an extended position. The wire between the cell group and connector is approximately 10cm, giving you plenty of flexibility to fit the battery where you need it. As always, measure up before you buy!

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a mini-Tamiya connector and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A LiPo battery with a universal electric pistol connection that will allow it to be used in pretty much every Airsoft Electric Pistol we can think of.

A 7.4v 1450mAh LiPo stick battery suitable not only for Airsoft but for RC vehicles and toys too.

A compact LiPo Airsoft Battery, designed to be used in tight awkward spaces, without compromising on overall capacity. It comes supplied with the more efficient Deans connector already installed.

If you need spare batteries for your AEP with a bit more oomph than the standard NiMh, this will do it! The IPower 7.4v 680mAh 20c LiPo Micro Battery is designed for CYMA CM.1xx series AEPs, fitted with a standard AEP connector and sized to fit AEP battery compartments. This battery is NOT compatible with AEP SMGs like the VZ61, MAC-10 or SMG-7 or the MOSFET-equipped CM.1xxS series.

This battery can be charged via its balance port using a LiPo balance charger, and as always, we recommend never leaving a LiPo on charge unattended and always using a LiPo charging bag.

If you're looking for the very smallest LiPo batteries, you've found them. Measuring 6.5 x 1.3 x 2.5 cm, this is the perfect battery for HPA systems with a JST-type connector.

The battery has a voltage of 7.4V, a capacity of 800 mAh, a discharge rate of 25C and features a cable length of roughly 10.5cm.

This ultra-thin Specna Arms 7.4V 1000mAh 30C Micro PEQ LiPo Battery is perfect for a PEQ box wired gun, such as the Specna Arms SA-H01. It can squeeze into some tight spots, but with its dimensions of 6.5x1x3.5cm, it will sadly not fit in PDW stocks but may fit in some SMG and AR36 handguards.

As it is a 7.4V LiPo, it is compatible with pretty much every Airsoft gun, and its Deans-style connector is optimal as most modern Airsoft guns are coming with Deans connectors installed due to its lower electrical resistance when compared with Tamiya connectors. If you need a teeny tiny battery for something, the Specna Arms 7.4V 1000mAh 30C Micro PEQ LiPo Battery; Deans could be your best shout!

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. 

A high quality and ultra compact 7.4v Lithium Polymer Battery with 850mAh of capacity, wth a 30C discharge rating.

A 7.4v Lithium Polymer Battery designed for use in battery compartments with limited space for a thin, but long battery.

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

If you're looking for spare batteries for your EMG JW3 AEP, this Specna Arms Gens Ace 7.4V 25C 620mAh G-Tech battery for AEPs is ideal! A 7.4V 2S LiPo with 620mAh capacity, this battery is pre-wired to a mini-Deans connector and a G-Tech balance plug. The G-Tech balance plug allows you to charge this battery on either a standard LiPo balance charger or the advanced G-Tech Charger from Gens Ace.

During our testing, we found this battery to be an incredibly tight fit in most AEPs, so we only recommend it for the EMG CM.138 JW3 AEP. Please note, if you do attempt to install this battery on other AEPs, it is likely you will damage the outer coating, which will invalidate your warranty. If you need to keep your JW3 AEP in the fight for longer, the Specna Arms Gens Ace 7.4V 25C 620mAh G-Tech battery for AEPs is the way to go!