CYMA CM.122S MOSFET Edition

This Airsoft Electric Pistol is based on the 226 series Pistol made by Sig Sauer, but accepts standard AEP magazines to make it compatible with any AEP mags you already have. The main feature of the pistol is the MOSFET and integrated LiPo battery which makes them easy to run, and higher performance than your typical AEP. It features both Semi and Full Automatic fire modes, which are selected via the marked fire selector in front of the pistol grip. The gun has a safety which can be engaged to prevent the trigger from being pulled. To activate it just twist the slide release lever above the trigger. It also has an adjustable HOP which allows you to backspin the BBs to increase range at the cost of accuracy. 

To make adjustments, remove the top slide by pulling down the catch at the top of the pistol grip, pull the slide forwards and up. The HOP is then adjusted by the gear-style adjustment wheel on the side. The magazine holds a total of 34rnds which is more than enough to spray at the enemy in a panic, or to make a competitive sidearm for CQB situations. The underside of the frame has a mock 20mm rail which may accept some specific types of RIS accessories, but should be treated as an aesthetic mock rail.

If you're looking for an easy to use and dependable sidearm as a backup or primary weapon for CQB situations, which has consistent performance due to not having to mess around with gas, then the CYMA CM.122S MOSFET Edition is the perfect sidearm for you.

Features

• 226 Series AEP Replica
• Electric Powered Pistol
• MOSFET Edition
• High Rate of Fire
• Semi & Full Auto Fire
• Standard AEP Magazines
• Trigger Lock Safety
• Adjustable HOP
• Gear Style HOP Adjust
• Alloy Upper Slide
• Mock 20mm Rail
• Consistent Performance
• Perfect CQB Gun
• Battery/Charger NOT Included
• Mini-Deans connector - Requires 7.4V 500mAh LiPo with Mini-Deans connector

Package Includes

• CYMA CM.122S MOSFET Edition
• 34rnd Magazine
• Speedloader

Special Instructions

To remove the Slide from the Pistol to install the battery the following method must be used to avoid damage to the pistol;

1. When looking at the pistol sat on its side with the barrel pointing to the left, there are 3 levers, the rear lever closest to the hammer pulls down, if you do not pull this slide down, you will break the two weakest points at the very rear of the pistol, that are to the left and right of the hammer.

2. The slide must be moved forward approx. 5mm

3. Only once the slide has been moved forward should the slide then be gently lifted up and off the lower frame.

4. To refit the slide please follow the above in reverse.

*Please note if you feel any resistance when lifting the slide off the pistol then STOP and ensure the slide has been moved forward, as failure to do this will result in breakage of the tabs that hold the slide securely in place.

All pistols that have been Two Toned, will have been checked for any damage prior to sending.

Physical damage caused to the pistol by failure to correctly remove the slide cannot be covered, and any pistols returned to us that have suffered damage in this manner will unfortunately have to be returned to you unrepaired. 

The externals of the replica are metal where they would be on the real world gun. This includes things like the outer barrel, handguard, and receiver. If a real world gun has polymer parts then the gun will still be marked as full metal externals, examples of this would be an M4, where the Stock and Pistol grip are always made from Polymer.