All Airsoft Batteries

An ideal battery for those who have very limited space or for those who have a front wired PEQ box style setup or RC cars. With a 1000mAh 30C discharge expect a good rate of fire but 2 or 3 are recommended for a full day of constant shooting.

A compact yet high output LiPo battery designed for most M4 stock tubes, solid stocks and some hand guards.

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries.

A crane stock Lithium Polymer (LiPo) type battery, which allows for the best possible power to size ratio and charge life available in a compact battery.

A standard Alkaline 9v battery from VAPEX which can be used for a wide array of Airsoft accessories as well as other hobbies such as RC Cars, Planes, Boats and other DIY projects.

A LiPo saddle battery designed to fit in handguards in replacement of the traditional 1600mAh NiMH blocks/saddles (G36 handguards etc).

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a mini-Tamiya connector and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

Those of you looking for a battery with a truly large capacity, you've come to the right place! The battery is perfect for larger battery compartments such as SMG-5, G3, M16 and AK platforms with fixed stock battery compartments. The battery has a voltage of 7.4v, a capacity of 2800mAh and a continuous discharge rate of 25C with a maximum discharge rate of 50C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 13x1.1x4.2cm with a cable length of roughly 10cm.

The perfect battery to give you enough juice for a full weekend of Airsoft milsim action. 9.6v and 4300mAh of power. Commonly used within M249, M16 and M14 variants.

If you need a battery for a fixed stock or other large battery compartments this one should fit the bill! The 7.4V 1800mAh 20C Block LiPo Battery from Electro River is the perfect battery for full stocks found on M16, AK, SMG-5 and G3 Airsoft AEGs. The battery measures 10 x 1.2 x 3.5cm approximately with a wire length of around 9cm and is pre-wired to a mini-Tamiya battery connector.

The battery is a 7.4V 2-cell battery in block configuration with a continuous discharge rate of 20C and a maximum discharge rate of 40C, making it great for almost any Airsoft AEG, though make sure you measure before ordering!

An 11.1v 2000mAh Li-Ion battery for Airsoft Electric Guns, which comes supplied in a Crane/Butterfly/Saddle configuration, meaning two rows of cells. This makes them very easy to place in awkard-to-fit spots such as Handguards and Crane Stocks, and will provide better Power Density that traditional LiPo batteries.

If you need a compact Airsoft battery which fits almost anywhere the 7.4v 1100mAh 20C LiPo Crane Battery from VAPEX is ideal. This battery is pre-wired with a mini-Tamiya battery connector and each cell unit measures 11 x 0.7 x 2.2 cm with approximately 9 cm of wiring between each cell and the connector, making it great for tight spaces and use with multiple different platforms.

The compact size of this crane/nunchuck battery makes it ideal not only for Airsoft but also for electronics hobby applications and R/C when a lightweight and compact power source is a priority. Whether it needs to fit into a buffer tube, crane stock, handguard or practically anywhere else this super slim battery is perfect, especially if you want a single battery which fits in multiple guns!

An ideal pack of 4 x AA batteries to power your accessories, from remotes to optics and more.

A singular CR2016 3V Lithium button battery which is commonly used for accessories such as sights and torches/lasers.

A pack of two AG3 LR41 batteries which are perfect for a range of Airsoft accessories and are ideal for keeping spare for Airsoft skirmishes to make sure you aren't taken out of the fight by a dead battery.

If you need an Airsoft battery that fits in almost anything and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo/ LiFe/NiMH Balance Charger, a Safe Charging Bag and an ASG 7.4V 1300mAh LiPo Battery in Crane configuration with a Mini-Tamiya connector; an ideal setup for Mini-Tamiya equipped AEGs and capable of fitting inside Crane stocks, fixed stocks and most handguards! If you have multiple different AEGs and you want a battery to fit them all, chances are this one will! 

The dimensions of the included battery are as follows: 10.1cm x 0.7cm x 2cm per cell group (2x cell groups on each battery) with approximately 10cm of wiring between the battery and connector. 

Compatible with: M4/AR-15 Crane Stock, M4/AR-15, SMG-5 & AK Fixed stock, AR-36 & SMG-5 handguards, Tokyo Marui SCAR-L/H NGRS stock, most M4/AR-15 buffer tubes. 

If you like to be at the cutting edge of battery technology when it comes to Airsoft, you're going to want to check this out! The Gens Ace 7.4V 25C 1000mAh Airsoft LiPo Battery - Mini-Tamiya is a slim LiPo battery intended for Airsoft buffer tube battery compartments, AK top covers and other cramped spaces requiring a single cell group. The discharge rate is 25C, giving you a snappy response without risking overspin in most setups, and the capacity is 1000mAh, meaning you might need two to get through a full game day. 

Where this battery differs from the norm is its Smart Balance Connector which interfaces with the Gens Ace IMARS Mini Charger, communicating the battery type and current charge levels and immediately commencing optimal charging as soon as this "Smart Battery" is connected. Compared to legacy smart chargers, this saves loads of time but unfortunately means that this battery cannot be charged using a standard LiPo balance charger. 

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

The perfect battery to give you enough juice for a full weekend of Airsoft milsim action. 9.6v and 3700mAh of power. Commonly used within M249, M16 and M14 variants.

A blister pack of 10 x 1.5v Lithium button batteries that are commonly used in Airsoft sights, scopes and other accessories.

If you're running an upgraded or MOSFET-equipped AEG, this Gens Ace 11.1v 25C 1500mAh LiPo Battery may be just what you need to power it. This Lithium Polymer (LiPo) battery is pre-wired to a Deans/T-Plug battery connector and consists of 3 cell groups wired in nun-chuck/crane/butterfly configuration. The wire length between the cells and connector is approximately 8cm and each of the 3 cells measures approximately 0.8 x 1.6 x 13 cm. 

Not all Airsoft AEGs are capable of running an 11.1V LiPo without causing damage, if you are unsure check the recommended battery section of the your gun's product description. LiPo batteries require balance charging, meaning this battery MUST be charged using a LiPo balance charger with the balance port connected. We recommend using a battery charging bag for storage and charging, and to never leave an Airsoft battery on charge while unattended. 

A strip of two LR66 / LR626 batteries of a 1.5V individual voltage, perfect for any accessories that run this strange size of watch battery.

If you need a battery for your AR36 AEG or polymer handguard equipped M4/AR-15 AEG this one will do the trick! The 7.4v 1800mAh 20C LiPo Flat Nunchuck Battery from Electro River is a flat nunchuck style battery, also known as a "butterfly" configuration. Unlike other nunchuck batteries, this won't inside a crane stock and is more suitable for large polymer handguards such as those found on AR36 and M4A1 AEGs and will also fit nicely in most fixed rifle stocks.

The battery itself is a 2-cell 7.4V LiPo with a wire length of approximately 9cm between the cell groups and the connector, and each of the two cell groups measures 10 x 0.6 x 3.5cm approximately. The pre-wired connector is the common mini-Tamiya type and the continuous discharge rate is 20C, with a maximum discharge rate of 40C.

An 8.4V 1600mAH stick battery with a Mini-Tamiya connector which can be charged using a standard NiMH charger. This battery's stick configuration makes it ideal for folding stock AK type AEGs or others with a long, thin battery compartment.

If you need a slim stick battery for your ASG Scorpion, M4/AR-15 AEG buffer tube or top-wired AK AEG this will do the trick! The Gen's Ace 7.4v 1500mAh 25C LiPo Stick Battery measures approximately 12x1.5x1.6cm which makes it perfect for rear wired M4 platforms with the standard buffer tube battery compartment, top wired AKs which house their battery beneath the top cover and SMG-5K platforms. The battery is pre-wired to a Mini-Tamiya connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEG and a perfect fit for the ASG Scorpion EVO 3A1, though make sure you measure before ordering!

A high quality 11.1V LiPo battery with a 1200mAh capacity, suitable for both Airsoft and RC use.

This battery features a wider and flatter butterfly style configuration and while it won't fit in crane stocks it is perfect for larger areas such as AR36 handguards and full stock rifles. The battery has a voltage of 7.4v, a capacity of 1500mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however adaptors are available.

The battery consists of two cells working in tandem with each other, with each cell measuring 8.5x0.6x3.4cm with a cable length of roughly 9cm.