All Airsoft Batteries

An 11.1v 1300mAh 20c LiPo Battery in a PEQ Box configuration, which makes it perfect for hiding inside a PEQ Box. It has a 9cm cable with a Deans Connector on the end, and total dimensions of: 1.65cm x 4.15cm x 6.6cm.

A high quality 11.1V LiPo battery with a 1200mAh capacity and Dean connector, suitable for both Airsoft, RC and more.

A high powered Airsoft Battery, designed to be used in highly tuned top-end gearbox. The battery comes in a 'stick' configuration, with two adjoined cells in one block, allowing the battery to be squeezed into even the tightest of buffer tubes. 

An 11.1v 1200mAh 20c LiPo Battery with a Deans Connector in a Stick configuration, making it ideal for Solid Stocks and some rear wired Buffer Tubes. It has the following dimensions with a 9cm cable: 2cm x 1.63cm x 13cm.

Suitable not only for Airsoft but for RC vehicles and toys too, this 7.4v 1550mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries wouldn't normally.

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space. 

An 11.1v 1200mAh 20c LiPo Battery in a Slim Stick configuration, complete with a Deans Connector. It has total dimension of: 1.35cm x 1.62cm x 18.5cm and is perfect for up-rated guns and rifles with a high power draw such as DMRs and high rate of fire setups, and other replicas that require a Stick Battery down the Receiver, such as AK/UMP models.

A LiPo crane stock battery designed to fit in stocks and small spaces which other large batteries do not fit.

Those of you with limited battery space, this block battery is the one! The battery will fit near enough all AEG rifles and will be especially useful in rifles with PDW stocks. It has a voltage of 7.4v, a capacity of 2800mAh and a discharge 30C. The battery is connected to your AEG via the Deans connector, not to be confused with Mini-Tamiya connector, however, adaptors are available.

The battery measures 7.5x1.5x2.5cm with a cable length of roughly 4cm.

A high voltage Airsoft Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

If you're looking for a tiny LiPo battery for your Novritsch SSE18 or CYMA CM.1xxS MOSFET equipped AEP, this is what you need. The Novritsch 7.4V 600mAh LiPo Battery measures approximately 7.3 x 1.5 x 1cm and is pre-wired with a Mini-Deans battery connector and a 3 port balance connector. 

As with other LiPo batteries, this battery should only ever be charged on a LiPo balance charger, preferably in a battery charging bag and should not be left on charge unattended under any circumstance.

If you need a compact 7.4V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 7.4V 800mAh 20c LiPo Stick Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and measures 10.2 x 1.1 x 1.9 cm with 5cm of wire length, making it suitable for most Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configurations with a Mini-Tamiya connector; an ideal setup for a Mini-Tamiya equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2x cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

Suitable not only for Airsoft but for RC vehicles and toys too. This Stick Battery is relatively large and excellent for ensuring you get a full day's play out of one charge, providing you're not too trigger happy.

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space. 

A LiPo battery with a universal electric pistol connection that will allow it to be used in pretty much every Airsoft Electric Pistol we can think of.

Those of you looking for a battery with a large capacity in a medium-sized block form factor, you've come to the right place! The battery is perfect for larger areas such as full-stocked SMG-5, G3, M16 and AK platforms, AR36 handguards and full-stock rifles. The battery has a voltage of 7.4v, a capacity of 2300mAh and a continuous discharge rate of 20C with a maximum discharge rate of 40C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with a Deans connector, however, adaptors are available.

The battery measures 10x1.5x3.4cm with a cable length of roughly 10cm.

If you need a battery for your M4/AR-15 AEG Crane stock and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery in Crane configuration with a Deans connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a Crane stock battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 0.7cm x 1.5cm per cell group (2 cell groups on each battery) with approximately 9cm of wiring between the battery and connector. 

An ultra-thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c. The battery is so thin it can fit into stock tubes and AK/MP5 AEG Battery compartments.

If you need a battery for your handguard or full stock battery compartment this should do the trick! The 7.4v 1600mAh 25C LiPo Battery from Giant Power is nice and compact, measuring 9.5x1.2x3cm approximately, making it great for handguard battery compartments in SMG-5 and AR36 AEGs and also an easy fit in M16 and AK full stocks.

The battery is pre-wired with a mini-Tamiya battery connector and is in block configuration, meaning both cells are bound together. The wire length between the battery itself and the connector is approximately 10cm and the continuous discharge rate is 25C, making this battery ideal both for Airsoft and any electronics hobby which requires a compact power source.

If you need a compact block battery for a handguard or fixed stock with limited space this should do the trick! The 7.4V 1500mAh 20C LiPo Block Battery from Electro River measures 8.5 x 1.2 x 3.4cm approximately with a wire length between the cell group and connector of approximately 9cm.

The pre-wired connector is the Deans/T-plug the continuous discharge rate is 20C and the maximum is 40C, making this battery great for both Airsoft applications and electronics hobbies.

A compact 7.4v two cell stick battery that is ideal for squeezing into small spaces like stock tubes, especially the battery spaces on Honey Badgers and compact weapons with an extending skeleton stock.

A 7.4v Lithium Polymer Battery designed for use in battery compartments with limited space for a thin, but long battery.

If you're looking for an 11.1V LiPo well suited to top wired AK platforms, this is the one! The Gens Ace 11.1V 1400mAh 25C LiPo Slim Stick Battery is pre-wired to a Deans connector and balance plug, measuring approximately 19.5 x 1.4 x 1.8 cm. This 3S 11.1V LiPo battery has a 25C discharge rating and 1400mAh capacity, making it well suited to AEGs with electronic trigger units or other high power-draw needs.

This battery is ideal for top-wired AK AEGs and SMG-5K platforms with a battery compartment inside the receiver, being slimmer than standard buffer tube style stick batteries. If you want to take full advantage of the lengthy battery compartment in your top-wired AK or SMG-5K, the Gens Ace 11.1V 1400mAh 25C LiPo Slim Stick Battery is the way to go!

A humungous 7.4v LiPo battery in a Crane Stock / Nunchuck configuration which offers a massive 3000mAh capacity. If you want the biggest battery you can possibly squeeze into your replica, this is probably it!

A super thin triple crane stock 11.1v 1300mAh 25C LiPo that features a standard Tamiya connector and is made up of three individual thin cells, making it great for squeezing into awkward spaces.

Giant Power are well known for their high quality and high performance batteries with this one being a block form factor. The battery has a voltage of 7.4v, has a capacity of 1300mAh and a discharge rate of 35C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery's dimensions are 7x1.5x3.4cm with a cable length of roughly 7.5cm. This battery should fit AEGs with larger battery compartments such as full stock AKs and M16s, within the handguard of AR36s and front wired MP5s.

An 11.1v 1300mAh 20c LiPo Battery with a Deans Connector in a Stick configuration, making it ideal for Solid Stocks and some rear wired Buffer Tubes. It has the following dimensions with a 9cm cable: 2cm x 1.62cm x 12.8cm.

This 11.1v 1300mAh 15C LiPo Stick Battery is a high quality battery suitable for Airsoft and RC use. Being a single stick type this battery will fit into most Airsoft AEG hand guards or stocks and stock tubes.

If you need a battery for your M4/AR-15 AEG buffer tube and would rather get everything you need in one place, here it is! This bundle includes a NUPROL LiPo Balance Charger, a Safe Charging Bag and a 7.4V 1450mAh LiPo Battery with a Mini-Tamiya connector; an ideal setup for a Deans equipped rear wired M4/AR-15 AEG with a buffer tube battery compartment. 

The dimensions of the included battery are as follows: 11.4cm x 1.3cm x 1.5cm with approximately 9cm of wiring between the battery and connector