All Airsoft Batteries

An 11.1v 1200mAh 20c LiPo Battery with a Deans Connector in a Stick configuration, making it ideal for Solid Stocks and some rear wired Buffer Tubes. It has the following dimensions with a 9cm cable: 2cm x 1.63cm x 13cm.

This LiPo battery from Gens Ace is designed to fit into flat and long battery compartments, such as those found inside the handguards of an AR36 or SMG-5. The battery connects to your AEG via a Deans connector (aka a T-Plug) and provides 1300mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

An ultra-thin and lightweight battery, perfect for squeezing into even the tightest spots. This battery provides 1200mAh of power with a discharge rate of 30c. Being short and wide, this battery is perfect for PEQ boxes and solid stocks.

An absolutely massive 11.1v 2000mAh Li-Ion battery in a stick configuration, which allows you to squeeze as much lifespan out of your Airsoft Electric Gun as possible, by offering a lower cost and higher power density vs. LiPo batteries.

If you're running an upgraded or MOSFET-equipped AEG, this Gens Ace 11.1v 25C 1500mAh LiPo Battery may be just what you need to power it. This Lithium Polymer (LiPo) battery is pre-wired to a Deans/T-Plug battery connector and consists of 3 cell groups wired in nun-chuck/crane/butterfly configuration. The wire length between the cells and connector is approximately 8cm and each of the 3 cells measures approximately 0.8 x 1.6 x 13 cm. 

Not all Airsoft AEGs are capable of running an 11.1V LiPo without causing damage, if you are unsure check the recommended battery section of the your gun's product description. LiPo batteries require balance charging, meaning this battery MUST be charged using a LiPo balance charger with the balance port connected. We recommend using a battery charging bag for storage and charging, and to never leave an Airsoft battery on charge while unattended. 

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A 7.4v 1450mAh LiPo stick battery with Deans connectors, suitable for Airsoft in addition to other application such as RC vehicles and toys too.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards  and comes fitted with Deans connectors instead of the standard Tamiya for upgraded Airsoft Guns.

A high quality 1300mAh 7.4V LiPo battery suitable for Airsoft and RC use, coming fitted with an upgraded Deans Connector rather than the standard Mini Tamiya.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya. 

If you're looking for an 11.1V LiPo which fits neatly into an AR buffer tube, this is the one! The VP Racing 11.1V 1300mAh 25c LiPo Stick Battery - Deans measures approximately 10.4 x 1.9 x 1.9 cm with 4cm of wire length, making it great for buffer tubes and other cramped but relatively long battery compartments. As always, make sure you measure your battery compartment before ordering to avoid disappointment!

A triple crane stock 11.1v 1450mAh 25C LiPo, which features a Deans connector instead of the standard small Tamiya.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too, this variant of the battery is fitted with a Deans connector for upgraded Airsoft Gun connectors, rather than the standard Mini Tamiya.

If you need a compact 11.1V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 11.1V 800mAh 20c LiPo Stick Battery should do the trick. This 11.1V 3S LiPo stick battery is fitted with a Deans battery connector and measures 10.4 x 1.7 x 1.9 cm with 4cm of wire length, making it suitable for upgraded Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. Fitted with a deans connector for low resistance.

This LiPo battery from Gens Ace is designed to fit into compact and slim battery compartments, such as the M4/AR15 buffer tube and the AK47/74 top cover. The battery connects to your AEG via a Deans connector (AKA T-Plug) and provides 1400mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8.5cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A 7.4v 1000mAh single stick battery that is ideal for squeezing in small compartments where space is a premium, particularly M4/15/16 stock tubes and those rear wired weapons with small battery spaces.

If you need a battery to fit into a tight place, Evolution Airsoft have you covered with the 7.4V 1100mAh 20C LiPo Stick Battery. This battery comes pre-wired with a Deans battery connector, also known as a "T-Plug" but is packaged with a Deans to mini-Tamiya adapter, meaning it can be used with almost any Airsoft AEG around.

The battery is a 2 cell 7.4V LiPo battery in stick configuration, meaning the cells are bound together into a single unit. The wire length between the battery and connector is approximately 10cm, the continuous discharge rate is 20C and the peak discharge rate is 40C. Whether you need a battery for your Airsoft gun or another electronics hobby which requires a compact power source, this Evolution Airsoft battery will do the trick!