All Airsoft Batteries

An 11.1v 1450mAh 30C LiPo in a stick configuration, which features a Deans connector instead of the standard small Tamiya.

A High voltage Airsoft LiPo Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

A LiPo stick battery for Airsoft, RC Cars and many other hobbies which comes as a stick configuration with a Deans connector. This battery is perfect for top-wired receivers and rear wired buffer tubes.

A thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c and is so thin it can fit into stock tubes and AK/MP5 AEG Battery compartments.

A LiPo Battery for Airsoft Electric Guns, with a 7.4V rating and 1200mAh capacity. This LiPo Battery is laid out in a Nunchuck / Crane Stock configuration, which makes it ideal for Handguards and AR Stocks thanks to the slim design. If you own a battery-powered Airsoft Gun and need a compact LiPo with a sensible capacity, then these are perfect for you. Features a Mini Tamiya Connector.

High quality WE 11.1v 1450mAh 30C LiPo Stick Battery, provides great battery life and fits most battery compartments. The 30C rating means the battery discharges quicker to give a higher rate of fire and better trigger response.

This 7.4v 1100mAh LiPo Stick Battery from NUPROL delivers high rate of fire, reliability and durability at a low cost. It can be easily stored in the front end of most popular AEGs such as an M4 or M16.

VP Racing are well known for their high quality and high performance batteries with this one being a crane form factor. The battery has a voltage of 7.4v, has a capacity of 1450mAh and a discharge rate of 25C. The battery is connected to your AEG via the Mini-Tamiya connector, not to be confused with Deans connector, however adaptors are available.

The battery consists of two cells working in tandem, with each cell measuring 13x0.7x2cm each with a cable length of roughly 7.5cm of wire. The battery should fit in crane stock battery compartments such as M4s and some handguards and full stocks, but remember to measure up before hand!

A high quality 1300mAh 7.4V LiPo battery suitable for Airsoft and RC use, coming fitted with an upgraded Deans Connector rather than the standard Mini Tamiya.

A LiPo Battery for Airsoft Electric Guns, with an 11.1v rating and 600mAh capacity. This compact 11.1v LiPo is ideal for PDWs and Airsoft Guns with a small battery space (specifically the Specna Arms PDWs), and features a Mini Tamiya Connector to connect to your AEG. If you have an Airsoft Gun that needs an 11.1v Battery, and has a tight battery compartment, then this is the ideal LiPo for you.

A compact LiPo Airsoft Battery, designed to be used in tight awkward spaces, without compromising on overall capacity. It comes supplied with the more efficient Deans connector already installed.

A compact LiPo Airsoft Battery, designed to be used in tight awkward spaces, without compromising on overall capacity. 

If you need slim 7.4V crane stock LiPo for your crane stock or handguard battery compartment, the VP Racing 7.4V 1000mAh 20c LiPo Crane Stock Battery should do the trick. This 7.4V 2S LiPo stick battery is fitted with a Deans battery connector and is comprised of 2 cells, each of which measures 11 x 1.5 x 0.5 cm. The wire length between the cells and connector is approximately 10cm, giving you a bit of flexibility to ensure the battery is installed properly. As always, we recommend measuring thoroughly to ensure it fits before ordering!

A 7.4v 1450mAh LiPo stick battery with Deans connectors, suitable for Airsoft in addition to other application such as RC vehicles and toys too.

This LiPo battery from Gens Ace is designed to fit into compact and slim battery compartments, such as the M4/AR15 buffer tube and the AK47/74 top cover. The battery connects to your AEG via a mini-Tamiya connector and provides 1000mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8.5cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya. 

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too, this variant of the battery is fitted with a Deans connector for upgraded Airsoft Gun connectors, rather than the standard Mini Tamiya.

If you are heavy on the trigger with your LiPo ready AEP you might need a couple of these! The IPower 7.4V 680mAh 20c LiPo battery is just like a normal LiPo stick, but much much smaller. This battery is designed as a spare battery for the CYMA CM.xxxS series of LiPo-ready AEPs and is pre-wired to a mini-Deans connector. This battery can be charged like a normal LiPo battery; using the balance lead and with a LiPo balance charger. This battery cannot be charged with a normal NiMh/NiCad charger, do not attempt it as you may cause a fire. If you are the creative type this battery's minuscule form could lend itself well to an electronics project or R/C use.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards  and comes fitted with Deans connectors instead of the standard Tamiya for upgraded Airsoft Guns.

A triple crane stock 11.1v 1450mAh 25C LiPo, which features a Deans connector instead of the standard small Tamiya.

A super thin, triple cell crane stock styled 11.1v LiPo battery, featuring a small Tamiya connector for easy use.

A stick battery designed for most M4 stock tubes, solid stock sand some hand guards. An ideal starter LiPo which you should get half a days use out of at least from a slow charge.

A high quality 1300mAh 11.1V LiPo battery suitable for Airsoft and RC use. A single stick type battery that will fit into most Airsoft AEG hand guards or stocks and stock tubes.

If you need a slim stick battery for your AK or SMG-5 AEG this will do the trick! The Giant Power 7.4v 1300mAh 25C LiPo Stick Battery measures approximately 18.5x1x2cm, which makes it perfect for longer battery compartments such as AK dust covers and SMG-5 platforms. The battery is pre-wired to a Mini-Tamiya connector and the length of wire between the cell group and the connector is approximately 6cm.

The battery is a 7.4V 2-cell battery in stick configuration with a continuous discharge rate of 25C, making it great for almost any Airsoft AEGs, RC cars and more!

A compact LiPo Airsoft battery, designed to be used in tight awkward spaces, without compromising on overall capacity.

If you're looking for the very smallest of LiPo batteries, you've found it. Measuring 4x1.3x2cm, this battery can be used to power the FCU in the V12 engine, in addition to other HPA systems with a mini-JST type connector.

The battery has a voltage of 7.4v, a capacity of 250mAh and a discharge rate of 20C and features a cable length of roughly 10.5cm

If you need a compact 11.1V LiPo for your buffer tube, PDW stock or other cramped battery compartment, the VP Racing 11.1V 800mAh 20c LiPo Stick Battery should do the trick. This 11.1V 3S LiPo stick battery is fitted with a Deans battery connector and measures 10.4 x 1.7 x 1.9 cm with 4cm of wire length, making it suitable for upgraded Airsoft AEGs, even those with small battery compartments. As always, we recommend measuring thoroughly to ensure it fits before ordering!

If you're looking for an 11.1V LiPo which fits neatly into an AR buffer tube, this is the one! The VP Racing 11.1V 1300mAh 25c LiPo Stick Battery - Deans measures approximately 10.4 x 1.9 x 1.9 cm with 4cm of wire length, making it great for buffer tubes and other cramped but relatively long battery compartments. As always, make sure you measure your battery compartment before ordering to avoid disappointment!

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. Fitted with a deans connector for low resistance.

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries.