All Airsoft Batteries

This LiPo battery from Specna Arms is designed to fit into crane stocks. The battery connects to your AEG via a mini-Tamiya connector and provides 2000mAh capacity with a 15C discharge rating.

The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 12cm, allowing some flexibility when squeezing the battery into tight spaces. The Specna Arms 7.4V 2000mAh 15C LiPo Nunchuck/Crane Battery; Tamiya would be great for any Airsoft gun which requires a 7.4V LiPo, but can also be used for other electronics hobbies.

If you're after an 8.4V NiMh for an AR36 or SMG-5 handguard battery compartment, the GFC 8.4V 1600mAh Ni-Mh Block Battery; Mini Tamiya is a perfect fit! A 7-cell rechargeable NiMh battery pre-wired to a mini-Tamiya battery connector, this Block configuration battery is ideal for fixed stock battery compartments, along with AR36 and SMG-5 handguard battery compartments. Wire length is approximately 10cm, giving you a bit of extra flexibility for easy installation. 

The advantage of NiMh batteries over their LiPo batteries is that they are less volatile and don't require balance charging, so you can use any charger as long as it's NiMh compatible. Just make sure not to leave the battery charging unattended, and as always, we recommend using a battery safe charging bag for both storage and charging. 

If you need a battery for a top-wired AK platform or an SMG-5K, this one is a perfect match! The Specna Arms 7.4V 1200mAh 20C LiPo Stick Battery (Mini-Tamiya) is designed for long, narrow battery compartments, measuring roughly 18cm x 1cm x 1.5cm, with an 11cm wire length, and comes pre-fitted with a Mini-Tamiya connector.

This 7.4V LiPo is made up of 2 cells combined into a single pack, delivering a 20C continuous discharge rate, 40C peak discharge, and a 1200mAh capacity.

This LiPo battery from Specna Arms is designed to fit into flat and long battery compartments, such as some handguards or crane stocks. The battery connects to your AEG via a Mini-Tamiya connector and provides 1300mAh capacity with a 15C discharge rating.

The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 10.5cm, allowing an easier fit into tighter spaces. The Specna Arms 11.1V 1300mAh 15C LiPo Nunchuck Battery; Mini-Tamiya would be great for any Airsoft gun which requires an 11.1V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.

If you're looking for a battery for a top-wired AK setup or an SMG-5K, this battery is the perfect fit! Electro River 7.4V 1200mAh 20/40C LiPo Slim Stick Battery; Mini-Tamiya is ideal for long, slim battery compartments, measuring approximately 18.5cm x 0.8cm x 1.4cm with a 10cm wire length, and is pre-wired to a Mini-Tamiya connector. 

This 7.4V LiPo consists of 2 cells bound together into a single cell group, with a 20C continuous discharge rate, a peak discharge rate of 40C and a capacity of 1200mAh. 

If you're running an M4 with a crane stock and need a longer-lasting battery, the GFC 9.6V 2200mAh Ni-Mh Nunchuck Battery; Mini Tamiya is a good shout. A battery of 8 cells formed into a single long cell group, this 9.6V rechargeable NiMh battery is a perfect fit for M4 AEGs with a Crane battery stock (or similar battery stock design) and also fits great in AEGs with fixed stock battery compartments (M16, etc.). Please note, to install this battery in a Crane Stock-equipped M4, you will need to place one of the cell groups inside the buffer tube. 

The advantage of NiMh batteries over their LiPo batteries is that they are less volatile and don't require balance charging, so you can use any charger as long as it's NiMh compatible. Just make sure not to leave the battery charging unattended, and as always, we recommend using a battery safe charging bag for both storage and charging. 

If you're after an 8.4V NiMh battery for a crane stock battery compartment, the GFC 8.4V 1600mAh Ni-Mh Crane Stock Battery; Mini Tamiya is ideal. A 7-cell rechargeable NiMh battery pre-wired to a mini-Tamiya battery connector, this Crane configuration battery is ideal for rear-wired M4/AR-15 AEGs with Crane stock battery compartments. Wire length is approximately 10cm, giving you a bit of extra flexibility for easy installation. 

The advantage of NiMh batteries over their LiPo batteries is that they are less volatile and don't require balance charging, so you can use any charger as long as it's NiMh compatible. Just make sure not to leave the battery charging unattended, and as always, we recommend using a battery safe charging bag for both storage and charging. 

If you need a NiMh battery for a top-wired AK or SMG-5K/MP5K AEG, the GFC 9.6V 1600mAh Ni-Mh Stick Battery; Mini Tamiya is the way to go! A battery of 8 cells formed into a single long cell group, this 9.6V rechargeable NiMh battery is a perfect fit in AK AEGs with a battery compartment inside the dust cover or SMG-5K/MP5K AEGs with a battery housed inside the receiver. 

The advantage of NiMh batteries over their LiPo batteries is that they are less volatile and don't require balance charging, so you can use any charger as long as it's NiMh compatible. Just make sure not to leave the battery charging unattended, and as always, we recommend using a battery safe charging bag for both storage and charging. 

A LiPo Crane Stock battery designed to fit in stocks and small spaces which other large batteries do not fit. The battery is also know as a Nunchuck battery, with the cells connected via the wires allowing them to be placed down the side of barrels or in an M4 Crane Stock.

A LiPo stock tube battery designed to fit in buffer tubes and small spaces which other large batteries do not fit.

A ultra thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c, giving it a 20w output.

A High voltage Airsoft LiPo Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

A stick 7.4v 1100mAh LiPo designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries, intended to allow Airsofters to get the best possible performance from their Airsoft Electric Guns.

A quality battery produced by VP Racing and designed for electronic products such as Airsoft AEG rifles and remote controlled cars etc. Holding a charge of 9.6V at 1600mAh, this battery will easily last all day of Airsoft gaming.

A 7.4v rated LiPo Battery for Airsoft Electric Guns, specifically ones that need a compact battery for a small space, such as PDW Stocks and Pistol Grips. The Battery has a 600mAh Capacity and a 20/40C Discharge Rate, as well as having a Mini Tamiya Connector to make it compatible with a huge range of Airsoft Guns. If you need a compact 7.4v LiPo for a Specna Arms PDW or other Airsoft Gun with a tight battery space, then this is the ideal choice.

A compact block style battery from GFC Energy. The battery is comprised of 8 1.2V cells, providing 9.6V total voltage. This battery is ideally shaped for use inside an AR36 polymer handguard, a solid stock battery compartment in an SMG5, or a vertical grip battery box. This battery is wired to a mini-Tamiya connector, and can also be used for RC vehicles or other electronics hobbies.

A large stick type battery, designed to output a high power for fast trigger response and rate of fire for up to three quarters of a day on a slow charge.

A Battery designed to fit into most Crane Stocks, this is a 7 cell Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers as part of their POWER range of Batteries. 

A LiPo Battery for Airsoft Electric Guns, with an 11.1v rating and 600mAh capacity. This compact 11.1v LiPo is ideal for PDWs and Airsoft Guns with a small battery space (specifically the Specna Arms PDWs), and features a Mini Tamiya Connector to connect to your AEG. If you have an Airsoft Gun that needs an 11.1v Battery, and has a tight battery compartment, then this is the ideal LiPo for you.

A 9.6v 1600mAh NiMh battery in stick configuration, often used within Airsoft AK AEGs. With a slow charge you can expect up to a whole day of Airsoft action from one charge.

A LiPo crane stock battery designed to fit in stocks and small spaces which other large batteries do not fit.

A LiPo crane stock battery designed to fit in crane and solid stocks, where other batteries would be wasting the available space.

A high quality 11.1V LiPo battery with a 1200mAh capacity, suitable for both Airsoft and RC use.

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries.

This is a high quality NUPROL 8.4v 1600mAh NiMH stick battery often used within Airsoft AK AEGs, or other weapons that features a long, thin battery compartment.

An ultra thin and lightweight battery, designed to squeeze into AK compartments. The battery provides 1100mAh of power with a discharge rate of 40C.

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too. 

Popular VP Racing 8.4v 1600mAh stick battery often used within Airsoft AK AEGs, or other weapons that features a long, thin battery compartment.

A 7.4v 1500mAh LiPo battery that provides a 20c discharge rate and is highly compact, making it ideal for external PEQ battery boxes and tight, square spaces.

Suitable not only for Airsoft but for RC vehicles and toys too, this  7.4v 2200mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries would normally not.