NUPROL 11.1v 1600mAh 20c Block LiPo Battery

The battery is constructed from individual Lithium Polymer cells which are protected by durable shrink wrapping and features a mini-Tamiya connector to connect it to your weapon. This battery is a BLOCK design and, as such, is best suited to larger battery compartments. It may fit in certain crane stocks or handguards, but be sure to measure your gun first to avoid disappointment. 

The battery is built using a high-quality silicon wire, which is more flexible than a regular cable, which makes it easier to squeeze into tight spaces. These batteries are also perfect for Remote Control Cars, Boats and other RC vehicles. This battery is the perfect purchase for Advanced Airsoft Skirmishers with highly upgraded High Rate of Fire or Power Guns. Please ensure when purchasing this battery you are fully aware of the power of the battery. Using this battery in Standard or non-upgraded Airsoft Weapons can cause permanent damage. Should you need help in figuring out if this battery is for you, please call us on: 01484 644709 and ask for the workshop department.

Features

• Part of the Nuprol POWER range
• Specifically designed for airsoft
• High quality battery cell
• Block style cell configuration
• 3 x 3.7v cells
• 1600mAh capacity 
• 20c discharge rating
• 10cm of cable
• Flexible silicon wiring
• Mini-Tamiya connector 

Package Includes

• 11.1v 1600mAh 20c LiPo Block Battery
• Instruction Manual

Special Instructions

Please note that we only recommend that this battery be used in Highly upgraded guns, and as such we cannot provide a warranty on any gun which has had an 11.1v battery used on it.

Please do not let the battery fully discharge before recharging, this will damage the battery, please use a LiPo Alarm to check the Charge of the Battery before use, and stop if the Rate of Fire Drops. To charge the battery you MUST use a Li-Po Battery Charger, as overcharging can cause damage to the unit.

Never leave Li-Po charging unattended - Always monitor the charging process of your Li-Po so that you can react immediately to any potential problems. If your batteries start to balloon or swell up discontinue charging / discharging. Before and after the use of your Li-Po batteries, inspect them to ensure there is no physical damage or swelling as those are signs of an imminent failure. 

Only use approved Li-Po chargers. Do not pierce or disassemble the battery. The charging current should not be more than 1A as charging at a higher current may damage the cell or even lead to overheating or leakage. Stop charging immediately when temperature is over 45°C, and stop using the battery once the temperature is over 60°C.

We recommend that all LiPo batteries be charged in a fire resistant location, and inside a Fire Proof bag, such as the VP Racing Battery Giant Power LI-PO GUARD Charging Bag.