ASG 11.1V 1300mAh 25c LiPo Crane Stock Battery

ASG
Code: 17207
£20.95
  • 1300mAh
  • 11.1v 3S LiPo
  • Crane Battery

A high powered Airsoft Battery, designed to be used in highly tuned top-end gearbox. 

Full description

Description

The battery comes in a 'butterfly' configuration, with three different cells, allowing the battery to be squeezed into even the strangest spots. The battery is designed to ideally fit in Handguards and Crane Stock style M4 stock, but will also squeeze into a variety of wonderful places. The battery features a 25c continuous discharge rate, and can supply a standard 26A discharge, with 32.5A burst. The batteries can also be used in remote control Cars, Boats, Planes and other Toys, as well as in DIY Electronics projects.

Features:

  • Individual Cell Approx. 10.1cm x  0.7cm x  2.1cm
  • Combined Cell Approx. 10.1cm x 2.1cm x 2.1cm
  • 10cm Cable
  • High Powered battery for increasing motor rate
  • Can be placed in combined or separated to fit the required space
  • 25c continuous discharge rate
  • 26A discharge rate, with 32.5A burst rate
  • Align Balance Connector

Package Includes:

  • 11.1V 1300mAh 25c LiPo Crane Stock Battery

Special Instructions:

Please note that we only recommend that this battery be used in Highly upgraded guns, and as such we cannot provide a warranty on any gun which has had an 11.1v battery used on it.

Please do not let the battery fully discharge before recharging, this will damage the battery, please use a LiPo Alarm to check the Charge of the Battery before use, and stop if the Rate of Fire Drops. To charge the battery you MUST use a Li-Po Battery Charger, as overcharging can cause damage to the unit.

Never leave Li-Po charging unattended - Always monitor the charging process of your Li-Po so that you can react immediately to any potential problems. If your batteries start to balloon or swell up discontinue charging / discharging. Before and after the use of your Li-Po batteries, inspect them to ensure there is no physical damage or swelling as those are signs of an imminent failure. 

Only use approved Li-Po chargers. Do not pierce or disassemble the battery. The charging current should not be ore than 1.0c as charging at a higher current may damage the cell or even lead to overheating or leakage. Stop charging immediately when temperature is over 45°C, and stop using the battery once the temperature is over 60°C.

We recommend that all LiPo batteries be charged in a fire resistant location, and inside a Fire Proof bag.

Specification

General

Product Length
Approx. 10.1cm
Product Height
Approx. 2.1cm
Product Width
Approx. 2.1cm
Patrol Base - Warning Icon
Warnings
Li-Po - Never Leave Charging Unattended
Li-Po - Only Use Approved Chargers
Li-Po - Charge in a Fire Safe Area

Battery Specification

Battery Type
Li-Po
Battery Configuration
Crane
Battery Connector
Patrol Base | Icon | Mini Tamiya
Mini Tamiya
Battery Voltage
11.1V
Battery Amperage
1300mAh
Battery Discharge Rate
25
Battery Cell Count
3
Battery Cell Voltage
3.7V
Battery Cell Height
0.7cm
Battery Wire Length
10cm

Size guide

Airsoft Battery should only be charged with the chargers as they are specifically designed to work with the specific voltages required by the battery.

Different battery types have different chemical configurations, and require certain chargers to charge them. Charging a battery with the wrong charger can cause damage to the battery and charger, and can cause fires and further damage. Please ensure that before charging you double check that you are using the correct charger.

If your charger supports multiple battery types always ensure that it is on the correct settings before starting the charge.

If you are unsure of what battery or charger you have please get in touch with us via the Contact Us Page.


Need something to charge your LiPo?