LiPo Batteries

If you run a front-wired AEG with limited battery space, storing your battery in a PEQ-15 battery box could be the solution! This 7.4V 850mAh 20C LiPo battery from Electro River is designed to fit into cramped spaces and is the perfect size for use in a PEQ-15 battery box. The battery measures  5.5 x 3 x 1.5cm approximately, and the wire length between the cell group and connector is approximately 11cm.

The compact size of this battery makes it great for both Airsoft and any other electronics projects you have on the go, providing plenty of juice in a smaller form factor. The continuous discharge rate of this battery is 20C, and its peak is 60C, giving you a nice snappy response without overdoing things!

A LiPo stock tube battery designed to fit in buffer tubes and small spaces which other large batteries do not fit.

A ultra thin and lightweight battery, perfect for squeezing into even the tightest spots. The battery provides 1200mAh of power with a discharge rate of 20c, giving it a 20w output.

Need a battery and a charger for your upgraded AEG? Get both at once with the Specna Arms Set EASY Charger With an 11.1v 1000mAh Battery! This package has everything you need to get started with 11.1V batteries. The balance charger ensures that all your battery's cells are charged equally, it also works for 7.4V batteries.

11.1V batteries should only be used with upgraded platforms, the high voltage and discharge rate can cause excess wear on internal parts inside stock AEGs. However, if your Airsoft rifle is built to take 11.1V batteries you will notice an improved rate of fire, snappier trigger response and possibly even an increase in FPS.

A Lithium Polymer battery for Airsoft, RC Cars and many other hobbies which comes as a Crane Stock configuration with a Deans connector. This battery is perfect for rear wired Crane Stocks and front wired handguards, and especially AEGs that require an 11.1v battery.

A 7.4v LiPo Battery for Airsoft Electric Guns, specifically the Specna Arms PDW range and other replicas with a tight/compact Battery Compartment. The Battery has a capacity of 600mAh, and a discharge rate of 20/40C. The compact size of the Battery makes it ideal for PDW Stocks, Pistol Grips, PEQ Boxes and other tight battery spaces.

A stick 7.4v 1100mAh LiPo designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries, intended to allow Airsofters to get the best possible performance from their Airsoft Electric Guns.

A 7.4v rated LiPo Battery for Airsoft Electric Guns, specifically ones that need a compact battery for a small space, such as PDW Stocks and Pistol Grips. The Battery has a 600mAh Capacity and a 20/40C Discharge Rate, as well as having a Mini Tamiya Connector to make it compatible with a huge range of Airsoft Guns. If you need a compact 7.4v LiPo for a Specna Arms PDW or other Airsoft Gun with a tight battery space, then this is the ideal choice.

If you want the biggest stick battery you can squeeze into your M4/AR-15 buffer tube, this is probably it! The Specna Arms 7.4v 2000mAh 15/30c LiPo Stick Battery is pre-wired to a mini-Tamiya battery connector and designed for slim and long battery compartments. The battery is a 7.4V LiPo with a capacity of 2000mAh, continuous discharge rate of 15C and maximum discharge rate of 30C.

The battery measures 12.3 x 1.6 x 1.8cm approximately and should fit into most M4/AR-15 buffer tubes, though some with less space inside may require that you leave the stock in an extended position. The wire between the cell group and connector is approximately 10cm, giving you plenty of flexibility to fit the battery where you need it. As always, measure up before you buy!

A LiPo battery for Airsoft Electric Guns which has been designed to output a high power for fast and consistent trigger response and high rate of fire for up to 3 quarters of a day on a slow charge. 

An 11.1v rated LiPo Battery for Airsoft Electric Guns, featuring a Deans Connector to provide an efficient connection to your AEG. With a 600mAh Capacity, the overall dimensions are quite small, making it ideal for PDW Stocks, Pistol Grips and other really tight Battery Compartments.

A LiPo Battery for Airsoft Electric Guns, with an 11.1v rating and 600mAh capacity. This compact 11.1v LiPo is ideal for PDWs and Airsoft Guns with a small battery space (specifically the Specna Arms PDWs), and features a Mini Tamiya Connector to connect to your AEG. If you have an Airsoft Gun that needs an 11.1v Battery, and has a tight battery compartment, then this is the ideal LiPo for you.

If you're looking for an 11.1V LiPo which fits neatly into an AR buffer tube, this is the one! The VP Racing 11.1V 1300mAh 25c LiPo Stick Battery - Deans measures approximately 10.4 x 1.9 x 1.9 cm with 4cm of wire length, making it great for buffer tubes and other cramped but relatively long battery compartments. As always, make sure you measure your battery compartment before ordering to avoid disappointment!

A compact LiPo battery designed for crane stock use but also suitable for compact Airsoft hand guards too, this variant of the battery is fitted with a Deans connector for upgraded Airsoft Gun connectors, rather than the standard Mini Tamiya.

A high quality 1300mAh 7.4V LiPo battery suitable for Airsoft and RC use - perfect for fitting down stock tubes and areas with a small amount of space.

A super thin triple crane stock 11.1v 1300mAh 25C LiPo, which features a Deans Connector instead of the standard Mini Tamiya. 

A triple crane stock 11.1v 1450mAh 25C LiPo, which features a Deans connector instead of the standard small Tamiya.

If you need a battery for your M4/AR-15 buffer tube or your top-wired AK AEG this should be perfect! The VAPEX 7.4v 1300mAh 20C LiPo Stick Battery measures 14 x 1.2 x 1.8cm approximately with a wire length of 9cm, making it a good fit in rear wired M4s with a buffer tube battery compartment, SMG-5K AEGs or AK AEGs in the top-wired configuration.

The pre-installed battery connector is the common mini-Tamiya type and the battery has a discharge rate of 20C, making it ideal for Airsoft applications but also useful for those needing a compact power source for electronics or R/C projects.

If you need spare batteries for your AEP with a bit more oomph than the standard NiMh, this will do it! The IPower 7.4v 680mAh 20c LiPo Micro Battery is designed for CYMA CM.1xx series AEPs, fitted with a standard AEP connector and sized to fit AEP battery compartments. This battery is NOT compatible with AEP SMGs like the VZ61, MAC-10 or SMG-7 or the MOSFET-equipped CM.1xxS series.

This battery can be charged via its balance port using a LiPo balance charger, and as always, we recommend never leaving a LiPo on charge unattended and always using a LiPo charging bag.

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries. 

A large stick type battery, designed to output a high power for fast trigger response and rate of fire for up to three quarters of a day on a slow charge.

Suitable not only for Airsoft but for RC vehicles and toys too, this  7.4v 2200mAh LiPo Stick Battery will fit in tight areas like stock tubes and handguards where other batteries would normally not.

An Airsoft Gun Battery designed and built by NUPROL specifically for Airsoft Skirmishers and are part of their POWER range of Batteries.

A 7.4v 1500mAh LiPo battery that provides a 20c discharge rate and is highly compact, making it ideal for external PEQ battery boxes and tight, square spaces.

A LiPo crane stock battery designed to fit in stocks and small spaces which other large batteries do not fit.

A large stick type LiPo battery, ideally suited to fitting inside an M4 or M16 type AEG stock tube.

An ultra thin and lightweight battery, designed to squeeze into AK compartments. The battery provides 1100mAh of power with a discharge rate of 40C.

Those of you with limited battery space, this block battery is the one! The battery will fit near enough all AEG rifles and will be especially useful in rifles with PDW stocks. It has a voltage of 7.4v, a capacity of 2800mAh and a discharge 30C. The battery is connected to your AEG via the Deans connector, not to be confused with Mini-Tamiya connector, however, adaptors are available.

The battery measures 7.5x1.5x2.5cm with a cable length of roughly 4cm.

A high voltage Airsoft Battery designed to give your weapon the highest rate of fire possible, in addition to lasting as long as possible, reducing the amount of time players spend changing batteries on a Skirmish day. 

This LiPo battery from Gens Ace is designed to fit into compact and slim battery compartments, such as the M4/AR15 buffer tube and the AK47/74 top cover. The battery connects to your AEG via a Deans connector (AKA T-Plug) and provides 1400mAh capacity with a 25C discharge rating. The battery is coated with heat shrink to prevent abrasion damage to the cells, and has a wire length of approximately 8.5cm, allowing some flexibility when squeezing the battery into small spaces. This battery would be great for any Airsoft gun which requires a 7.4V LiPo, but would also be of use for R/C vehicles, Drones or other electronics hobbies.